Results 21 to 30 of about 9,592,257 (290)
A Chopper Stabilization Audio Instrumentation Amplifier for IoT Applications
A low-noise instrumentation amplifier dedicated to a nano- and micro-electro-mechanical system (M&NEMS) microphone for the use in Internet of Things (IoT) applications is presented. The piezoresistive sensor and the electronic interface are respectively,
Jamel Nebhen +2 more
doaj +1 more source
This paper presents a low-noise chopper-stabilized zero-drift amplifier with successive approximation register (SAR)-assisted automatic offset calibration loop (AOCL).
Gibae Nam +9 more
doaj +1 more source
Circuits and Systems for Wireless Concurrent Communication [PDF]
Concurrency is a special kind of analog circuit parallelism that uses a single circuit with necessary bandwidth to process multiple signals at the same time. Concurrent radios offer a higher data rate and improved system diversity.
Wang, Yu-Jiu
core +1 more source
Differential ultra low noise amplifier for low frequency noise measurements
Almost all low noise voltage preamplifier suitable for application in the field of Low Frequency Noise Measurements (either commercially available or proposed in the literature) are single ended input amplifiers.
Graziella Scandurra +2 more
doaj +1 more source
Recent advancements in low power and low noise front-end amplifiers have made it possible to support high-speed data transmission within the deep roll-off regions of conventional wireline channels.
Yudhajit Ray, Shreyas Sen
doaj +1 more source
This paper presents a capacitively coupled chopper instrumentation amplifier (CCIA) with ultra-low power consumption and programmable bandwidth for biomedical applications.
Xuan Thanh Pham +2 more
doaj +1 more source
Investigation of the possibility of increasing the sensitivity of a microwave radiometer [PDF]
The results of a sensitivity study of various types of quadratic detectors for a microwave radiometer are presented, both with and without a low-noise amplifier.
Luchinin Alexander, Malygin Ivan
doaj +1 more source
FET input voltage amplifier for low frequency noise measurements [PDF]
The paper presents a low noise voltage FET amplifier for low frequency noise measurements. It was built using two stages of an op amp trans impedance amplifier.
Bielecki, Zbigniew +2 more
core +1 more source
56.6 dB high gain L-band EDFA utilizing short-length highly-doped erbium rare-earth material [PDF]
In this paper, we experimentally investigate the performance of an efficient high gain L-band erbium-doped fiber (EDF) amplifier structure utilizing short-length highly-doped erbium rare-earth material with a single pump source.
Al-Mansoori M. H., Al-Ghaithi W. S.
doaj +1 more source
Design And Analysis Of Low Noise Amplifier Using Cadence [PDF]
Low Noise Amplifier also known as LNA is one of the most significant component for application in wireless communication system. It is a very important part in RF receiver because it can reduce noise of gain by the amplifier when the noise of the ...
Idris, Muhammad Idzdihar +3 more
core +4 more sources

