Results 11 to 20 of about 7,783,593 (306)
Proceedings of the 11th international conference on Information Processing in Sensor Networks, 2012 ABSTRACT Traditionally, routing in wireless sensor networks consists of two steps: First, the routing protocol selects a next hop, and, second, the MAC protocol waits for the intended destination to wake up and receive the data. This design makes it difficult to adapt to link dynamics and introduces delays while waiting for the next hop to wake up.
Landsiedel, Olaf +3 more
openaire +8 more sources
Energies, 2023 The unique structure and physical properties of perovskite-type catalysts make them highly promising for catalyzing efficient coal combustion. Mesoporous perovskite LaNixFe1−xO3 (x = 0.2, 0.4, 0.6, 0.8) coal combustion catalysts were synthesized using ...
Guohong Wang +4 more
doaj +1 more source
Low Power Contactless Voltage Sensor for Low Voltage Power Systems [PDF]
Sensors, 2019 Contactless measurements represent the desirable solution in many contexts, where minimal cabling is required or, in general, cabling is not possible. This paper presents a new contactless voltage sensor for low voltage power systems. It is based on a contactless capacitive probe, which surrounds the power cable.
Delle Femine, Antonio +4 more
openaire +4 more sources
Low Power Dynamic Scheduling for Computing Systems [PDF]
, 2011 This paper considers energy-aware control for a computing system with two states: "active" and "idle." In the active state, the controller chooses to perform a single task using one of multiple task processing modes.
Neely, Michael J.
core +1 more source
Chemosensors, 2022 The increasing demand for rare earth elements (REE) requires faster analysis techniques for their rapid exploration. Laser-induced breakdown spectroscopy (LIBS) has on-site and real time analysis capability.
Muhammad Sher Afgan +6 more
doaj +1 more source
Ultralow-Power SOTB CMOS Technology Operating Down to 0.4 V
Journal of Low Power Electronics and Applications, 2014 Ultralow-voltage (ULV) CMOS will be a core building block of highly energy efficient electronics. Although the operation at the minimum energy point (MEP) is effective for ULP CMOS circuits, its slow operation speed often means that it is not used in ...
Nobuyuki Sugii +9 more
doaj +1 more source
Meitan xuebao, 2023 The conversion level of carbon in the process of biomass char utilization determines the overall efficiency of subsequent utilization, while the conversion rate of biomass char depends to a certain extent on the physical and chemical structure of biomass.
Xinyu WANG +6 more
doaj +1 more source
Low Power Explicit Pulse Triggered Flip-Flop Design Based On A Pass Transistor [PDF]
, 2016 In VLSI system design, power consumption is the ambitious issue for the past respective years. Advanced IC fabrication technology grants the use of nano scaled devices, so the power dissipation becomes major problem in the designing of VLSI chips.
Baviskar, P. P. (Prof) +2 more
core +1 more source
Review on Coupled Thermo-Hydraulic Performance of Nanofluids and Microchannels
Nanomaterials, 2022 As electronic components continue to be miniaturized, the heat flux density continues to increase. Scholars have proposed the use of microchannel heat sinks (MCHS) to dissipate heat from devices with high heat flux density, and have pointed out that the ...
Yuwei Wang +3 more
doaj +1 more source
Journal of Immunotoxicology, 2018 Immune cells are known as the most sensitive tissue for ionizing radiation. Numerous reports relating with the effect of low-dose ionizing radiation (LDIR) on immune activities showed that LDIR can induce immune-potentiation via modulating the activity ...
Seong-Jun Cho +4 more
doaj +1 more source