Results 71 to 80 of about 4,070 (230)

Analysis of Corrosion and Wall Perforation in the Heat Exchanger Made of AISI 316L Stainless Steel

open access: yesMaterials and Corrosion, EarlyView.
Elevated passivation temperature is identified as the dominant factor triggering localized corrosion and subsequent perforation of AISI 316L heat exchanger tubes. Electrochemical and complementary characterization results show that the alloy retains high resistance to general, pitting, and intergranular corrosion, indicating that failure primarily ...
Bojana Radojković   +7 more
wiley   +1 more source

Stress-induced α″ martensite and its variant selection in a metastable β titanium alloy under an uniaxial compression

open access: yesJournal of Materials Research and Technology
The phase transformation of β to stress-induced α″ martensitic progresses in a displacive mode. The associated transformation strain induced by β to α″ martensitic has an important influence on the resultant microstructure.
Ruifeng Dong   +5 more
doaj   +1 more source

Influence of Strain Rate on the Strain Hardening Behavior of a Lean Duplex Stainless Steel

open access: yesMetalMat, EarlyView.
The aim of this study was to examine how strain rate influences the compressive strain‐hardening behavior of a lean duplex stainless steel LDX 2101. Microstructural analysis using electron backscatter diffraction (EBSD) revealed a strain‐induced austenite‐to‐martensite transformation.
Akilakpa Sawyerr   +4 more
wiley   +1 more source

Nucleation and Martensitic Transformation in Subjects of Small Dimensions

open access: yesУспехи физики металлов, 2014
The existing models and schemes of the martensitic phase nucleation are considered in the review. Theoretical and experimental works devoted to the nucleation of the martensitic crystals in different metals are discussed and analysed.
V. A. Lobodyuk
doaj   +1 more source

Dislocations Help Initiate the α–γ Phase Transformation in Iron—An Atomistic Study

open access: yesMetals, 2019
Using molecular dynamics simulation, we studied the influence of pre-existing dislocations on the austenitic and the martensitic phase transformations in pure iron. The simulations were performed in a thin-film geometry with (100) surfaces. We found that
Jerome Meiser, Herbert M. Urbassek
doaj   +1 more source

Influence of Steel Recycling on Phase Transformation in Medium‐Manganese Third‐Generation Advanced High‐Strength Steels

open access: yessteel research international, EarlyView.
On the pathway to climate‐neutral steel production, recycling fractions will necessarily increase over time. Since alloying elements will enrich progressively, as they cannot be removed economically from the melt, processes need to be adjusted.
Anindita Chakraborty   +3 more
wiley   +1 more source

Martensitic Transformation Induced by B2 Phase Precipitation in an Fe-20 Ni-4.5 Al-1.0 C Alloy Steel Following Solution Treatment and Subsequent Isothermal Holding

open access: yesMetals
Phase transformations significantly influence the mechanical properties of Fe-based alloys, making their understanding essential for the design of high-performance alloy materials.
Rosemary Chemeli Korir   +2 more
doaj   +1 more source

Recycling‐Induced Copper Contamination of a 42CrMo4 Quench and Tempering Steel—Scaling and Susceptibility to Hot Shortness

open access: yessteel research international, EarlyView.
In this study, the susceptibility to copper‐induced hot shortness of the alloy 42CrMo4 is investigated by different hot tensile tests, as well as by a detailed analysis of the formed oxidation products. While an enrichment of metallic copper and a penetration of the grain boundaries are observed, no critical reduction of the tensile test properties can
Alexander Gramlich   +6 more
wiley   +1 more source

Alteration of Phase Transformation Behavior and Prior Austenite Grain Structure Due to Elevated Tramp Element Concentrations in a Hypoeutectoid Steel

open access: yessteel research international, EarlyView.
The phase transformation behavior of a hypoeutectoid steel is studied in comparison with alloys containing higher concentrations of tramp elements, simulating high recycling rates. The examination of microstructures reveals that the tramp elements facilitate the formation of displacive phases along with retained austenite.
Lukas Hatzenbichler   +7 more
wiley   +1 more source

Home - About - Disclaimer - Privacy