Results 31 to 40 of about 13,024,848 (326)
Material removal investigation in bonnet polishing of CoCr alloy [PDF]
, 2012 The manufacture of orthopaedic joint bearings surfaces requires exceptionally high levels of control of not only the surface finish but also the surface form.
Blunt, Liam, Zeng, S., Jiang, Xiang
core +3 more sources
Al-Qadisiyah Journal for Engineering Science, 2023 EDM (Electrical Discharge Machining) is a common non-traditional machining technique for manufacturing geometry parts made of intricate or extremely rigid metals that are challenging to manufacture using conventional manufacturing techniques.
Shukry H. Aghdeab +2 more
doaj +1 more source
Metals, 2021 The objective of this paper was to determine the optimum process parameters of an electric discharge machine while machining a new hybrid aluminum metal matrix composite.
Mandeep Singh +7 more
semanticscholar +1 more source
The Influence of Current & Pulse off Time on Material Removal Rate and Electrode Wear Ratio of Steel 304 in EDM [PDF]
Engineering and Technology Journal, 2015 EDM (Electric Discharge Machining)machine was used for machining of conducting cutting materials such as steel 304in dielectric solution (diesel fuel) by supplied byDC current values (10, 20, 30, 42 and 50A).
Shukry Hammed Aghdeab, Vian Nihad Najm
doaj +1 more source
Scientific Reports, 2022 Permanent-magnet small ball-end magnetorheological polishing method can be used to polish the small part with complex structure. However, the material removal rate of this method is low, which is difficult to improve the output and reduce the cost.
Jinchuan Tian +5 more
doaj +1 more source
Influence of Machining Parameters on Electro Discharge Machining of NiTi Shape Memory Alloys
International Journal of Electrochemical Science, 2013 NiTi is an alloy of nickel and titanium with important characteristics such as shape memory, superelasticity, high electrical resistance, high corrosion resistance, long fatigue life, and vibration absorption.
Saeed Daneshmand +3 more
doaj +1 more source
Applied Sciences, 2023 The rate of the removal of materials coated with nano−crystalline diamonds by femtosecond laser etching was examined by adjusting the repetition rate of the femtosecond laser, the energy−flux density of the concentrated spot, and the scanning speed.
Lujun Ren +5 more
doaj +1 more source
Journal of Mechanical Engineering and Sciences, 2022 The turning process is one of the significant machining processes widely applied in manufacturing industries. The study compared the minimum quantity lubrication turning process using sunflower oil lubrication and the dry turning process for AISI 316L ...
SIGIT YOEWONO MARTOWIBOWO +2 more
doaj +1 more source
Effect of the material properties on removal rate in SEDM
Journal of The Japan Society of Electrical Machining Engineers, 2011 Electric discharge machining has been widely used in making the arbitrary shapes for various metallic materials, and appropriate conditions for such machining have been selected mostly by trial machining in actual processes. However, the removal rate are depends on the fundamental thermal properties of the materials used.
YAMASHITA, Masahide +3 more
openaire +1 more source
The effects of lapping load in finishing advanced ceramic balls on a novel eccentric lapping machine [PDF]
, 2005 HIPed (Hot Isostatically Pressed) silicon nitride ball blanks were lapped from diameter 13.255 mm to diameter 12.7 mm by a novel eccentric lapping machine. A maximum material removal rate of 68 μm/hour has been achieved under a nominal lapping load of 43
Kang, J, Hadfield, M
core +1 more source