Results 51 to 60 of about 9,905 (238)
Evaluation and Comparison of Handedness and Maximum Bite Force in Right and Left Sides of Jaw: An In Vivo Study [PDF]
Aims and background: Handedness, a key indicator of cerebral dominance, may influence neuromuscular coordination and masticatory function. Understanding its correlation with bite force distribution can provide insights into chewing behavior and enhance ...
Shivam Paliwal +5 more
doaj +1 more source
Bite force of patients with tooth pain
Objectives The aim of this study was twofold: (i) to measure the bite force of healthy adults and patients with tooth pain and (ii) to evaluate the influence of bite force and age on tooth pain and both genders.
Yoshinobu Shoji +3 more
doaj +1 more source
A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt +4 more
wiley +1 more source
Background: Maximum bite force is a valuable objective metric for analyzing masticatory function and assessing the long- term success of implants. The aim of this cross-sectional observational study was to evaluate the maximum bite force of th patients ...
Nafiz Ahsan +4 more
doaj +1 more source
Association between skeletal malocclusion, masseter muscle volume, and bite force: CBCT study [PDF]
Background/Aim: This study aimed to evaluate the masseter muscle volume and maximum bite force in individuals with different types skeletal malocclusion.
Okkesim Alime, Misirlioglu Melda
doaj +1 more source
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source
ANALYSIS OF MAXIMUM BITE FORCE CORRELATING TO FACIAL MORPHOLOGY AMONG EGYPTIAN DENTAL STUDENTS [PDF]
Introduction: Occlusal forces are considered a vital aspect of any dental treatment plan. Maximum occlusal force is intended to be correlated with facial dimensions, gender, and race.
Tarek Farfour +2 more
doaj +1 more source
Temporomandibular joint disorders among implant patients in relation to bite force
Background: The installation of dental implants may impair the temporomandibular joint’s ability to operate by altering bite force. Aim: The aim of this study was to compare dental implant patients with partially and fully dentate patients in terms of ...
Rihab Abdul Hussein Ali +2 more
doaj +1 more source
ABSTRACT Electronic waste has emerged as a major environmental challenge, driven by the massive consumption and a limited lifetime of modern electronic devices, stimulating the development of sustainable electronics. Here, an all‐biomaterial gelatin‐choline‐citric acid ([Ch][CA]) ionogel is developed as an active binder to realize self‐sintered ...
Lin Guo +10 more
wiley +1 more source
This review revisits optoelectronic neuromorphic devices that extend from unimodal sensing toward multimodal perception. Five types of stimuli‐to‐output information flow that are classified based on the device roles within the system and applications are summarized and discussed.
Jihyun Shin +6 more
wiley +1 more source

