Results 111 to 120 of about 487,374 (296)
Modeling the initial mechanical response and yielding behavior of gelled crude oil
The initial mechanical response and yielding behavior of gelled crude oil under constant shear rate conditions were investigated. By putting the Maxwell mechanical analog and a special dashpot in parallel, a quasi-Jeffreys model was obtained. The kinetic
Lei Chen +4 more
doaj +1 more source
Simulation of Optical Fiber Amplifier Gain Using Equivalent Short Fibers
Electromagnetic wave propagation in optical fiber amplifiers obeys Maxwell equations. Using coupled mode theory, the full Maxwell system within an optical fiber amplifier is reduced to a simpler model.
Drake, Dow +3 more
core +1 more source
Aging Maxwell Constitutive Model for Concrete
Fully-hydrated concrete not involved in any reaction has been observed to exhibit aging creep. Both the solidification theory and the dissolution-precipitation theory are incapable of predicting such a behaviour. The microprestress theory proposed for this purpose is based upon an ambiguous physical mechanism.
Milan Suter, Gurmail S. Benipal
openaire +1 more source
In MOCVD MoS2 memristors, a current compliance‐regulated Ag filament mechanism is revealed. The filament ruptures spontaneously during volatile switching, while subsequent growth proceeds vertically through the MoS2 layers and then laterally along the van der Waals gaps during nonvolatile switching.
Yuan Fa +19 more
wiley +1 more source
Approximate models for the Maxwell equations
The problem of numerical investigation of low frequency phenomena described by the time-dependent Maxwell equations is considered. Initial and boundary conditions for the various approximate models are derived by using asymptotic analysis. Some application problems are also briefly discussed.
Raviart, Pierre-Arnaud +1 more
openaire +3 more sources
Integration of Low‐Voltage Nanoscale MoS2 Memristors on CMOS Microchips
This article presents the first monolithic integration of nanoscale MoS2‐based memristors into the back‐end‐of‐line of foundry‐fabricated CMOS microchips in a one‐transistor‐one‐resistor (1T1R) architecture. The MoS2‐based 1T1R cells exhibit forming‐free, nonvolatile resistive switching with ultra‐low operating voltages, low cycle‐to‐cycle variability ...
Jimin Lee +16 more
wiley +1 more source
NUMERICAL SIMULATION OF VISCOELASTIC MATERIALS
Purpose. The main goal of this paper is to develop the numerical model of viscoelastic material using finite element method (FEM). The model was applied to asphalt-aggregate mixtures.
S. P. Panchenko
doaj +1 more source
A class of linear viscoelastic models based on Bessel functions
In this paper we investigate a general class of linear viscoelastic models whose creep and relaxation memory functions are expressed in Laplace domain by suitable ratios of modified Bessel functions of contiguous order. In time domain these functions are
Colombaro, Ivano +2 more
core +1 more source
2D Magnetic and Topological Quantum Materials and Devices for Ultralow Power Spintronics
2D magnets and topological quantum materials enable ultralow‐power spintronics by combining robust magnetic order with symmetry‐protected, Berry‐curvature‐driven transport. Fundamentals of 2D anisotropy and spin‐orbit‐coupling induced band inversion are linked to scalable growth and vdW stacking.
Brahmdutta Dixit +5 more
wiley +1 more source
A Numerical Technique for Solving the Maxwell Model for Free Surface Flows
This work is concerned with the development of a numerical technique for solving free surface flows of a Maxwell fluid. The governing equations for the flow of a Maxwell type fluid together with appropriate boundary conditions are given. The free surface
D.M. Carvalho +4 more
doaj +1 more source

