Sperm swarm optimization for many objective power flow problems with enhanced performance evaluation in power systems. [PDF]
Mbasso WF +10 more
europepmc +1 more source
Electromigration Analysis for Interconnects Using Improved Graph Convolutional Network with Edge Feature Aggregation. [PDF]
Ye R, Chen X.
europepmc +1 more source
Influence of Solder Mask on Electrochemical Migration on Printed Circuit Boards. [PDF]
Klimtová M +3 more
europepmc +1 more source
Deployment and validation of a smart bed architecture for untethered patients with wireless biomonitoring stickers. [PDF]
Nunes T +6 more
europepmc +1 more source
Robust estimation of the three parameter Weibull distribution for addressing outliers in reliability analysis. [PDF]
Safari MAM +3 more
europepmc +1 more source
Myoclonus in Pediatric Metabolic Diseases: Clinical Spectrum, Mechanisms, and Treatable Causes-A Systematic Review. [PDF]
Majewska E +3 more
europepmc +1 more source
Post Wire-Bonding Corrosion Prevention Strategies to Mitigate Chloride- and Bromide-Induced Corrosion Failures in Cu- and PCC-Based Wire-Bonded Packages. [PDF]
Kumaravel DK +5 more
europepmc +1 more source
Related searches:
Instantaneous Mean-Time-To-Failure (MTTF) estimation for checkpoint interval computation at run time
Microelectronics Reliability, 2019Abstract The Mean-Time-To-Failure (MTTF) is an important parameter that determines the life-time reliability of a system. It is being used in several fault-tolerant mechanisms to take a critical decision on processor/system state. Recently it has been found that the MTTF of a system varies with the environmental conditions, in contrary to the earlier
Mohamad Imran bin Bandan +3 more
openaire +4 more sources
The effect of stress on the mean time to failure (MTTF) of solder under electromigration
2015 16th International Conference on Electronic Packaging Technology (ICEPT), 2015In this paper, we followed the advice of Prof. Tu to investigate the effect of stress on the electromigration behavior of solder. Static electromigration test and thermal cycle test (−55°C - 125°C) with maximum current density of 2×104A/cm2 were performed.
Xiaoxu Pan, Tianbao Lan, Fei Su
openaire +3 more sources
A Method for the Calculation of the Mean Time To Failure (MTTF) of Repairable System
Advanced Materials Research, 2008The ability of executing assigned function of repairable system under certain condition is quite different from that of single unit due to redundant configuration. It is well understood that proper management strategy can greatly prolong the mean time to failure (MTTF) of repairable system.
Jian Xin Zhu +4 more
openaire +3 more sources

