Results 161 to 170 of about 2,866,672 (202)
Some of the next articles are maybe not open access.

On the Mechanism of Forced-Convection Subcooled Nucleate Boiling

Journal of Heat Transfer, 1990
In highly subcooled nucleate boiling the bubbles grow and collapse while sliding along the heated surface, so that there is no net vapor transport away from the surface. A long-standing question exists as to whether conduction and convection between the bubbles, or latent heat transport through the bubbles, is the dominant heat transfer mechanism.
G. Tsung-Chang, S. G. Bankoff
openaire   +1 more source

On the mechanism of subcooled flow boiling of binary mixtures

International Journal of Heat and Mass Transfer, 1994
Abstract Correlations have been developed for forced convection subcooled boiling of binary mixtures using data on acetone-water, isopropanol-water and n- butanol-water systems. Separate correlations for the partial boiling region and for the fully developed boiling region incorporating the effects of degree of subcooling, liquid velocity and ...
P. Sivagnanam   +2 more
openaire   +1 more source

On the mechanism of onset of significant void in subcooled flow boiling

International Journal of Heat and Mass Transfer, 2021
Abstract Theoretical investigation was carried out for a possible mechanism of the onset of significant void (OSV) or net vapor generation (NVG) in subcooled flow boiling. Based on available knowledge on the two-phase flow regime transition from bubbly to slug flows, it was postulated that bubble coalescence is intensified substantially when the ...
openaire   +1 more source

On the effect of mechanical shocks on the congelation of subcooled plant tissues

Protoplasma, 1938
Cylindrical shells of potato tissue were slid around the bulb of a thermometer and subcooled. Attempt was then made to induce crystallization by tapping the upper end of the thermometer. Out of 122 trials 52 were successful. In a few experiments, 15 repeated taps were ineffective.
Basile J. Luyet, Eugene I. Hodapp
openaire   +1 more source

Thermodynamic Analysis and Comparison of Mechanical Subcooling Transcritical CO2 Refrigeration System With Expander and Throttling Valve

open access: yesCase Studies in Thermal Engineering
Mechanical subcooling is an efficient means of enhancing the performance of CO2 transcritical refrigeration systems. With the aim of further improving the system performance, this objective of this paper is the comparative analysis on mechanical ...
Qichao Yang, Yuanyang Zhao, Zeye Zheng
exaly   +2 more sources

Mechanisms of Subcooled Pool Boiling CHFS Depending on Subcooling, Pressure, and Test Heater Configurations and Surface Conditions in Liquids

Heat Transfer, Volume 3, 2002
The measured subcooled pool boiling CHFs on a horizontal cylinder heater for subcoolings with pressures as a parameter in water, liquid nitrogen, liquid helium etc. were previously well described by the subcooled pool boiling CHF correlations newly derived assuming two different CHF mechanisms resulting from hydrodynamic instability (HI) and ...
Akira Sakurai, Katsuya Fukuda
openaire   +1 more source

Viewpoint of Subcooled Flow Boiling Critical Heat Flux Mechanism

Chemical Engineering & Technology, 2002
In getting an overall viewpoint of critical heatflux (CHF) boiling mechanisms, first of all, we should have the awareness that the CHF triggering mechanism associates with the flow pattern development very much. For the subcooled flow boiling, due to the existence of two kinds of flow pattern, two kinds of CHF mechanism are considered existing.
W. Liu, H. Nariai
openaire   +1 more source

Mechanisms of Subcooled Water Flow Boiling CHFS for Outlet Subcooling at a Flow Velocity With Pressures for Test Sections With Various Shapes

Heat Transfer: Volume 2 — Heat Transfer in Multiphase Systems, 2001
Abstract The mechanisms and the correlations for the subcooled water flow boiling CHF, qct,sub, for outlet subcooling at fixed flow velocities with the pressure as a parameter measured were investigated using the existing database measured for the test sections such as a vertical metal strip in the channel with a wide cross section, and ...
Akira Sakurai, Katsuya Fukuda
openaire   +1 more source

On the Mechanism of Flashing Injection of Initially Subcooled Fuels

Journal of Fluids Engineering, 1984
The mechanisms responsible for flash-boiling injection were investigated. Using an electromagnetic injector developed for this study, propane, methanol and Indolene were heated and injected into a constant-volume vessel. Two regimes of flash-boiling injection were identified.
openaire   +1 more source

Vibration Mechanisms of a Heated Rod Due to Subcooled Boiling Flow

Volume 9: 6th FSI, AE and FIV and N Symposium, 2006
Vibration characteristics of subcooled boiling flow on thin and long structures such as a heating rod were recently investigated by the authors. The results show that the intensity of the subcooled boiling-induced vibration (SBIV) was influenced strongly by the conditions of subcooling temperature, linear power density and flow velocity.
M. R. Nematollahi, M. H. Akbari
openaire   +1 more source

Home - About - Disclaimer - Privacy