Thermodynamics of a vapor-compression refrigeration cycle with mechanical subcooling
Energy, 1994Abstract Refrigeration and air-conditioning systems, when operating under large temperature differences between the condenser and evaporator, consume significant amounts of energy. A vapor-compression refrigeration cycle with a mechanical subcooling loop to increase system performance and reduce energy consumption is investigated by using both the ...
openaire +1 more source
Bubble dynamics in subcooled nucleate boiling based on the mass transfer mechanism
International Journal of Heat and Mass Transfer, 1970Abstract A mathematical model for bubble dynamics in subcooled nucleate boiling is derived. This model is based on the mass transfer mechanism of evaporation and condensation through the bubble. The bubble is considered to be a control volume. Heat and mass balance couples transient heat transfer caused by evaporation and condensation with bubble ...
Theodore T Robin, Nathan W Snyder
openaire +1 more source
The invalidation mechanism of kinetic hydrate inhibitors under high subcooling conditions
Chemical Engineering Science, 2019Abstract Vinyl lactam-based polymers have been shown to be excellent kinetic hydrate inhibitors (KHIs), inhibiting the formation and growth of methane hydrate under low subcooling conditions. However, under moderate/high subcooling conditions, they lose their inhibitory effect and can even be converted into hydrate promoters.
Liwei Cheng +7 more
openaire +1 more source
Cost optimization of heat exchanger inventory for mechanical subcooling refrigeration cycles
International Journal of Refrigeration, 2013Abstract In this paper, thermoeconomic considerations are given to heat exchanger inventory allocation in vapor compression cycles with mechanical subcooling. Investigation is made with respect to constant work rate, heat rejection and cooling rates as well as heat transfer in the subcooler.
Bilal Ahmed Qureshi, Syed M. Zubair
openaire +1 more source
Subcooled void growth mechanisms and prediction at low pressure and low velocity
International Journal of Multiphase Flow, 1994Abstract Measurements were made of void growth and wall temperatures for two circular annular geometries and forced-convective subcooled nucleate boiling conditions, with flow rates between 0.02 and 0.20 kg/s, pressures of 1.05, 2 and 3 bar, and inlet temperatures between 30 and 90°C. Void growth results at low pressure show that the highly subcooled
E.L. Bibeau, M. Salcudean
openaire +1 more source
The mechanism of void formation in initially subcooled systems
1963When an initially subcooled, water filled system undergoes a transient in heat flux or pressure such that bubbles form, the most important variable which determines the volume of the resulting void is the number of bubbles that is formed. In this report the number of bubbles that are formed is shown to be a function of the surface micro-configuration ...
Griffith, P., Snyder, George A.
openaire +2 more sources
Thermodynamic Analysis of N2O Transcritical Cycle Using Dedicated Mechanical Subcooling
2021The thermodynamic analysis to improve the energetic performance of N2O transcritical cycle using dedicated mechanical subcooling is done for three different evaporator temperatures 5, −5 and −30 °C. The analysis is done for the environment temperature ranging from 30 to 40 °C. Propane is used as a refrigerant in mechanical subcooling cycle. It has been
Pradeep Kumar, Shivam Mishra
openaire +1 more source
Structural analysis of subcooled liquid argon based on the molecular-mechanics model
Soviet Journal of Low Temperature Physics, 1980The structure of subcooled liquid argon is analyzed on the basis of a model with 108 interacting particles. Estimates of the mobility of the particles in this system indicate a state corresponding to a vitrified liquid. Analysis by the method of “statistical geometry”, involving a construction of polyhedra for the instantaneous configurations of atoms ...
A. E. Galashev, V. P. Skripov
openaire +1 more source
Design and rating of dedicated mechanical-subcooling vapour compression refrigeration systems
Proceedings of the Institution of Mechanical Engineers, Part A: Journal of Power and Energy, 2000Subcooling of the refrigerant at the exit of the condenser in a vapour compression refrigeration system allows the refrigerant to enter the main cycle evaporator with a lower quality and thus allows the refrigerant to absorb more heat in the evaporator, thereby improving the coefficient of performance (COP) of the system.
J-ur-R Khan, S. M. Zubair
openaire +1 more source
Experimental data on the mechanism of subcooled water boiling: high-speed video shooting
Thermophysics and Aeromechanics, 2014The article provides statistical data on the characteristics of subcooled liquid boiling and behavior of vapor and air bubbles resulted from high-speed shooting. The authors have described a number of new phenomena going along with water boiling.
Yu. A. Zeigarnik +2 more
openaire +1 more source

