Results 1 to 10 of about 832,948 (254)
Index to 1984 NASA Tech Briefs, volume 9, numbers 1-4 [PDF]
, 1987 Short announcements of new technology derived from the R&D activities of NASA are presented. These briefs emphasize information considered likely to be transferrable across industrial, regional, or disciplinary lines and are issued to encourage ...
core +1 more source
Materials selection and design of microelectrothermal bimaterial actuators
, 2007 A common form of MEMS actuator is a thermally actuated bimaterial, which is easy to fabricate by surface micromachining and permits out of plane actuation, which is otherwise difficult to achieve.
Prasanna, S., Spearing, S.M.
core +1 more source
Galvanic corrosion behavior of AZ91D alloy / 45 steel couple under magnetic field
Journal of Magnesium and AlloysGalvanic corrosion behavior of AZ91D alloy / 45 steel couple in 3.5 wt.% NaCl solution under 0, 0.2 and 0.4 T magnetic field were studied by microstructure observation, immersion test and electrochemical measurement.
Xin Zhang +6 more
doaj +1 more source
Interfacial Stress Transfer in a Graphene Monolayer Nanocomposite
, 2010 Graphene is one of the stiffest known materials, with a Young's modulus of 1 TPa, making it an ideal candidate for use as a reinforcement in high-performance composites.
Baughman +29 more
core +1 more source
Journal of Materials Research and TechnologyMicro-alloyed Zn–Mg alloys have attracted extensive attention in the field of medical implant due to their excellent biosafety and moderate degradation rate.
Chengwei Ji +6 more
doaj +1 more source
Advanced methods for 3-D inelastic structural analysis for hot engine structures [PDF]
Three-dimensional Inelastic Analysis Methods are described. These methods were incorporated into a series of new computer codes embodying a progression of mathematical models (mechanics of materials, specialty finite element, boundary element) for ...
Chamis, C. C.
core +1 more source
Constitutive Models Based on Compressible Plastic Flows [PDF]
, 1983 The need for describing materials under time or cycle dependent loading conditions has been emphasized in recent years by several investigators. In response to the need, various constitutive models describing the nonlinear behavior of materials under ...
Rajendran, A. M.
core +1 more source
3-D inelastic analysis methods for hot section components (base program) [PDF]
A 3-D inelastic analysis methods program consists of a series of computer codes embodying a progression of mathematical models (mechanics of materials, special finite element, boundary element) for streamlined analysis of combustor liners, turbine blades,
Bak, M. J. +3 more
core +1 more source
Cracking Driving Force at the Tip of SCC under Heterogeneous Material Mechanics Model of Safe-End Dissimilar Metal-Welded Joints in PWR [PDF]
, 2022 Yuman Sun +6 more
openalex +1 more source