Results 31 to 40 of about 235 (182)
Model Free Traveling Wave Based Fault Location Method for Series Compensated Transmission Line
Locating fault position in a series compensated transmission line is a difficult task due to the non-linear characteristics of the metal-oxide varistor which is present in the protection system of the compensator. In this paper, a model-free two-terminal
O. D. Naidu, Ashok Kumar Pradhan
doaj +1 more source
Two basic ways to realise DC circuit breakers
As a key element of the DC grid, the technology of DC circuit breakers (DCCBs) still have difficulty to be widely used due to its large cost and volume. This paper studies the basic principle and its realisation methods for DCCBs.
Zheng Xu +3 more
doaj +1 more source
Reduction Reactive Power and Collapse Voltage Using Series Capacitors Compensation in Sudden Change Loads of Transmission Lines [PDF]
The continuous increase of disturbances on the interconnected electric power system resulting in its inability to reliably meet demands. This paper presents an application of a series capacitor compensation in transmission line and shunt reactors ...
Hussein Thani Rishag
doaj +1 more source
ABSTRACT This study examines the impact of aging on the electrical and structural properties of positive temperature coefficient of resistance (PTCR) ceramics. The presented study introduces a correlative scanning electron microscopy (SEM)/conductive atomic force microscopy (C‐AFM) approach enabling repeated, site‐specific characterization of ...
Kryštof Koller +4 more
wiley +1 more source
Metal oxide varistors (MOVs) are a type of resistor with significantly nonlinear current-voltage characteristics commonly used in power lines to protect against overvoltages.
Toni Gutknecht +4 more
doaj +1 more source
Condition monitoring and deterioration analysis of metal oxide varistor [PDF]
Abstract With the growing demand for application of metal-oxide varistor (MOV) in low-voltage electronic circuits for overvoltage protection, it is necessary to ensure its performance to avoid the short-circuit and the line-to-ground fault during operation.
Guoming Wang +3 more
openaire +1 more source
Strain‐Induced Redistribution of Point Defects in ZnO Nanoparticles
Powder compaction generates local strain effects in ZnO nanoparticles. This alters the abundance of intrinsic point defects and impacts the semiconductor's electronic structure. Such changes were analyzed by a combination of spectroscopy and density functional theory calculations and emphasize the importance of strain effects in the design and ...
Korbinian Aicher +4 more
wiley +1 more source
dv/dt Dependence in metal oxide varistors
A dv/dt dependence has been observed in metal oxide varis-tors during impulse testing. A lossy dielectric model which provides a qualitative explanation of this behaviour can also be used to account for current overshoot.
de Cogan, D., Leesen, M.
openaire +2 more sources
Ultra‐Rapid Blacklight Sintering for ZnO‐Based Varistors With Optimized Functional Properties
ABSTRACT The increasing demand for energy‐efficient optoelectronic systems has intensified interest in high‐performance ceramic varistors, which are critical components in surge protection applications. In this study, ZnO‐based varistors were fabricated using a novel blacklight sintering (BLS) technique, which employs high‐powered blue light, and were ...
Ahmad Sayyadi‐Shahraki +4 more
wiley +1 more source
Influence of UHV GIL access on transient recovery voltage of circuit breaker
The access of ultra high voltage (UHV) gas-insulated transmission line (GIL) affects both the transient recovery voltage (TRV) amplitude and the rate of rise of TRV (RRRV) of circuit breakers,which may endanger the breaking capacity of circuit breakers ...
SUN Yi +5 more
doaj +1 more source

