Results 181 to 190 of about 457 (219)
Some of the next articles are maybe not open access.
Investigation of various models for metal oxide varistors
Journal of Electronic Materials, 1976A new type of voltage dependent resistors (varistors), based on zinc oxide ceramics with several other metal oxides as additives, has recently been investigated. The microstructure of these varistors consists of ZnO grains surrounded by thin insulating metal oxide barriers.
J. Bernasconi +3 more
openaire +1 more source
Metal oxide varistors as surge suppressors
1995 International Conference on Electromagnetic Interference and Compatibility (INCEMIC), 2002High voltage transients and surges are produced due to lightning, inductive load switching, and spikes or electrical noise on power lines. These voltage surges can be as high as 6 kV and the transient period can vary from a few microseconds to milliseconds. The frequencies of these surges vary randomly depending upon the source voltage.
openaire +1 more source
Ageing of metal oxide varistors due to surges
2011 International Symposium on Lightning Protection, 2011Surge arresters are exposed to a series of stresses that trigger changes in their nonlinear behaviors. This paper deals with the ageing of metal oxide varistors concerning the stresses associated to high current short duration surges. The ageing of the samples is evaluated by analyzing the evolution of the resistive component of the leakage current ...
Credson de Salles +2 more
openaire +1 more source
Second-breakdown characteristics of metal-oxide varistors
Journal of Applied Physics, 1977Several new results on the electrical breakdown properties of ZnO-based ceramic varistors are presented. A second-breakdown phenomenon associated with thermal runaway and characterized by a negative differential conductivity was observed in dc tests. The curve of capacitance versus bias current exhibited hysteresis while the I-V characteristics became ...
J. J. Lee, J. K. O’Brien, M. S. Cooper
openaire +1 more source
Multi-factor ageing of metal oxide varistors
Proceedings of IEEE Conference on Electrical Insulation and Dielectric Phenomena - (CEIDP'94), 2002Localised overheating of zinc oxide varistor elements due to the transfer of external leakage currents arising from the incidence of partial electrical discharges (PD) onto their outer surface has been shown to cause premature failure by surface breakdown.
N.M. Vong +3 more
openaire +1 more source
Microwave Sintering Technology for the Production of Metal Oxide Varistors
MRS Proceedings, 1990ABSTRACTA microwave sintering technology has been developed for the production of metal oxide varistors. The electrical properties (leakage current and non-linearity coefficient) of the microwave sintered devices were found to be comparable to those obtained for conventionally sintered varistors of identical composition.
G. McMahon +4 more
openaire +1 more source
Development of metal oxide varistor element for power systems
Proceedings of IEEE International Symposium on Industrial Electronics, 2002A highly nonlinear arrester can improve the insulation coordination of electrical substations and reduce the basic impulse level of power systems. Metal oxide varistors with zinc oxide as one of their constituents are used as advanced protective devices for power systems against transient overvoltages.
S.N. Roy +3 more
openaire +1 more source
Research on leakage current characteristic of metal oxide varistor
2017 1st International Conference on Electrical Materials and Power Equipment (ICEMPE), 2017MOA (Metal Oxide Arrester) has been widely used in the world because of its excellent nonlinearity, long-lasting anti-aging properties and excellent overvoltage protection performance. The performance degradation of the MOV occurs in the long-running process because of environmental reasons, so the online monitoring system for the MOA has a great ...
Xuni Rao +4 more
openaire +1 more source
Metal oxide varistor-A multijunction thin-film device
Applied Physics Letters, 1974The physical origin of the highly nonlinear current-voltage relation in metal oxide varistors is shown to be consistent with Fowler-Nordheim tunneling.
Lionel M. Levinson, H. R. Philipp
openaire +1 more source
Barrier voltage measurement in metal oxide varistors
Journal of Applied Physics, 1976A combination of electrical and ceramic microstructural data has been used to determine the voltage drop across the ZnO-intergranular barrier in some simple and multicomponent ZnO-based varistors at the onset of high non-Ohmicity. The data are obtained by measuring the varistor breakdown field (V/mm) and average grain size of the conductive ZnO matrix ...
openaire +1 more source

