Results 21 to 30 of about 457 (219)
New Fault-Location Algorithm for Series-Compensated Double-Circuit Transmission Line
IEEE Access, 2020 This paper proposes a new fault location algorithm to accurately locate the faults of series-compensated double-circuit transmission line and improve the stability of power system operation, which is not affected by fault types. The proposed algorithm is
Daiying Cai, Jun Zhang
doaj +1 more source
IEEE Access, 2020 This article focuses on the problem that the voltage recovery time of relay protection circuits in converter stations is too long under lightning surges.
Yuqi Zhang, Weidong Zhang, Jianfei Ji
doaj +1 more source
IET Generation, Transmission & Distribution, 2022 This paper reports the observation results of three‐phase overvoltage at the lightning strike point of a 1.5 km, 10 kV power distribution line that was struck directly by rocket triggered lightning to its phase wire C.
Jianguo Wang +7 more
doaj +1 more source
Impulse Life Evaluation Method of MOV Based on Weibull Distribution
IEEE Access, 2021 The working life evaluation of metal oxide varistor (MOV) is always expected by MOV manufacturers and users. In Oct. 2019, the International Electrotechnical Commission (IEC) SC37B established a project team PT 61643–333 led by the author of this ...
Qibin Zhou +3 more
doaj +1 more source
Model Free Traveling Wave Based Fault Location Method for Series Compensated Transmission Line
IEEE Access, 2020 Locating fault position in a series compensated transmission line is a difficult task due to the non-linear characteristics of the metal-oxide varistor which is present in the protection system of the compensator. In this paper, a model-free two-terminal
O. D. Naidu, Ashok Kumar Pradhan
doaj +1 more source
Reduction Reactive Power and Collapse Voltage Using Series Capacitors Compensation in Sudden Change Loads of Transmission Lines [PDF]
Engineering and Technology Journal, 2012 The continuous increase of disturbances on the interconnected electric power system resulting in its inability to reliably meet demands. This paper presents an application of a series capacitor compensation in transmission line and shunt reactors ...
Hussein Thani Rishag
doaj +1 more source
Condition monitoring and deterioration analysis of metal oxide varistor [PDF]
Journal of Electrical Engineering, 2018 Abstract With the growing demand for application of metal-oxide varistor (MOV) in low-voltage electronic circuits for overvoltage protection, it is necessary to ensure its performance to avoid the short-circuit and the line-to-ground fault during operation.
Guoming Wang +3 more
openaire +1 more source
The Scientific World Journal, 2015 Metal oxide varistors (MOVs) are a type of resistor with significantly nonlinear current-voltage characteristics commonly used in power lines to protect against overvoltages.
Toni Gutknecht +4 more
doaj +1 more source
Two basic ways to realise DC circuit breakers
The Journal of Engineering, 2019 As a key element of the DC grid, the technology of DC circuit breakers (DCCBs) still have difficulty to be widely used due to its large cost and volume. This paper studies the basic principle and its realisation methods for DCCBs.
Zheng Xu +3 more
doaj +1 more source
Influence of UHV GIL access on transient recovery voltage of circuit breaker
电力工程技术, 2022 The access of ultra high voltage (UHV) gas-insulated transmission line (GIL) affects both the transient recovery voltage (TRV) amplitude and the rate of rise of TRV (RRRV) of circuit breakers,which may endanger the breaking capacity of circuit breakers ...
SUN Yi +5 more
doaj +1 more source