Results 1 to 10 of about 211,694 (117)
Microfluidic Airborne Metal Particle Sensor Using Oil Microcirculation for Real-Time and Continuous Monitoring of Metal Particle Emission [PDF]
Airborne metal particles (MPs; particle size > 10 μm) in workplaces result in a loss in production yield if not detected in time. The demand for compact and cost-efficient MP sensors to monitor airborne MP generation is increasing.
Jong-Seo Yoon +4 more
doaj +2 more sources
Three-dimensional dynamic simulation of motion characteristics of metal particle in DC GIL [PDF]
Dynamic behavior simulation of metal particles in gas-insulated metal-enclosed transmission lines (GIL) is crucial for predicting their migration process and distribution pattern.
Feng Bin +4 more
doaj +2 more sources
Sizing and quantification of micro- and nanoplastics by single particle ICP-MS: a comparison between quadrupole and high-resolution instruments [PDF]
Micro- and nanoplastics (MNPs) are widespread environmental pollutants of growing concern due to their persistence and impacts on ecosystems and human health.
Pia Leban +10 more
doaj +2 more sources
China’s 10-year progress in DC gas-insulated equipment: From basic research to industry perspective
The construction of the future energy structure of China under the 2050 carbon-neutral vision requires compact direct current (DC) gas-insulation equipment as important nodes and solutions to support electric power transmission and distribution of long ...
Chuanyang Li +26 more
doaj +1 more source
Epoxy insulators are widely used in Gas-Insulated Transmission Lines (GILs), playing a significant role in electrical insulation and mechanical support. The metal particles generated during the production and operation of the equipment aggravate surface ...
Wenqu Wang, Yu Gao, Huicun Zhao
doaj +1 more source
The Sn–3.0wt.%Ag–0.5wt.%Cu(SAC305) - xSiC composite solder was prepared by powder metallurgy method with the addition of SiC ceramic reinforcement with various compositions (0, 0.5, 1, and 1.5wt.%).
Manoj Kumar Pal +2 more
doaj +1 more source
Bottom-Up Metal/Oxide/Bi2Te3 Heterostructures for Enhanced Thermoelectric Properties
In this paper, metals’ (Cu, Ag, Au)/Al2O3/Bi2Te3 heterostructures have been fabricated to synergistically optimize their carrier concentration and mobility, thereby enhancing their thermoelectric power factor.
Zhenhua Wu, Zhiyu Hu
doaj +1 more source
When DC GIL in operation endures the lightning impulse voltage, the charge accumulation at the gas-solid interface area will seriously affect the insulation performance of the spacer.
Jian Wang +5 more
doaj +1 more source
Effect mechanism of dielectric-coated electrodes on metal particle lift-off in SF(6) gas
In order to study the influence mechanism of dielectrically coated electrode in SF(6) gas under DC electric field on metal particle lift-off, experimental platform is setup and motion trajectory is recorded by high-speed camera. The experiment shows that
Zhan Zhenyu +4 more
doaj +1 more source
Metal-assisted etching has attracted increasing attention as a method to produce porous silicon (Si). We previously found that gold (Au)-particle-assisted etching and platinum (Pt)-particle-assisted etching cause general corrosion of the Si substrate ...
Ayumu MATSUMOTO +5 more
doaj +1 more source

