Results 41 to 50 of about 9,362 (181)
A high interstital austenitic steel is additively manufactured and postdensified by HIP to eliminate gas porosity. Thereby, the loss of N and Mn in Ar HIP atmosphere is investigated. Further, HIP using N2 atmosphere is investigated which led to excessive nitride formation.
F. Großwendt +4 more
wiley +1 more source
The opportunity was taken in 2010 to carry out a full scientific and technical examination of the brass head from Ife, popularly known as the Olokun head, first published in 1912 by Leo Frobenius, together with a selection of other Ife heads that came to
Paul T. Craddock +6 more
doaj +1 more source
The influence of Fe particle size on in situ alloying of Fe–SiC powder blends in PBF‐LB/M is revealed. Contrary to expectations, the coarser Fe fraction provides a broader crack‐free processing window and slightly improved elemental homogeneity while producing higher but more variable hardness. The results highlight a complex trade‐off between particle
Anna Luise Strauch +2 more
wiley +1 more source
Sustainable Materials Design With Multi‐Modal Artificial Intelligence
Critical mineral scarcity, high embodied carbon, and persistent pollution from materials processing intensify the need for sustainable materials design. This review frames the problem as multi‐objective optimization under heterogeneous, high‐dimensional evidence and highlights multi‐modal AI as an enabling pathway.
Tianyi Xu +8 more
wiley +1 more source
Metallographic Study of Overlapped Laser Welds of Dissimilar Materials
The paper deals with the metallographic analysis of overlapped laser welds of dissimilar materials based on galvanized and ungalvanized steels in various combinations. In addition to a gallery of metallographic sections, the paper presents the monitoring
Anna Guzanová +8 more
doaj +1 more source
Abstract Purpose To investigate the effect of surface treatment and fabrication techniques of high‐performance polymers on their shear bond strength (SBS) to grade IV titanium. Materials and Methods A total of 120 pre‐milled titanium abutments were sectioned.
Ahmet Serkan Küçükekenci +3 more
wiley +1 more source
The Metallography of Aluminum Casting Alloys [PDF]
The purpose of this thesis is to supply the Montana School of Mines with an up to date source of information concerning the metallography of aluminum casting alloys. This thesis is designed as a continuing project.
Goehler, Donald D.
core +1 more source
The corrosion resistance of heat‐treatable aluminium alloys depends directly on the applied heat treatment. This article discusses the relationship between cooling rate and intergranular corrosion sensitivity. The intergranular corrosion depths were determined by light microscopy of cross‐sections and correlated with both non‐destructive eddy current ...
Hanna Schulz +3 more
wiley +1 more source
Metallography of stainless steels
This thesis deals with metallography of stainless steels. At the beginning of theoretical part the history of metallography is shortly summarized. Then the basic knowledge about metallography, ways and methods of preparing samples for subsequent analysis
Hasoňová, Michaela
core +1 more source
Application of metallography in failure investigations: some case studies [PDF]
Metallography is a tool to know the internal condition of the material and no investigation can be initiated without this. It can be both nondestruc¬tive i.e., in-situ metallography, as well as destructive i.e..
Sinha, A N
core +1 more source

