Results 111 to 120 of about 621,356 (276)

CANONICAL STRUCTURE OF GAUGE INVARIANCE PROCA'S ELECTRODYNAMICS THEORY

Momento, 2018
Proca's electrodynamics describes a theory of massive photons which is not gauge invariant. In this paper we show that the gauge invariance is recovered if a scalar field is properly incorporated into the theory.
German E. Zambrano, Bruto M. Pimentel
doaj   +1 more source

A Proof‐of‐Concept Assessment of a Novel Wearable Eyelid Muscle Device: A Pre‐Clinical Animal Cadaver Study for Eyelid Closure Restoration

Advanced Robotics Research, EarlyView.
This article introduces a soft wearable eyelid sling device incorporating a hydraulic soft artificial muscle (SAM) for achieving complete closure of an eyelid. The SAM is driven by a cam mechanism that provides a displacement profile closely matched with those of a healthy eyelid.
Patrick Pruscino, Phuoc Thien Phan, James Davies, Bibhu Sharma, Tianruo Guo, Chi Cong Nguyen, Nigel H. Lovell, Thanh Nho Do   +7 more
wiley   +1 more source

Collision‐Resilient Winged Drones Enabled by Tensegrity Structures

Advanced Robotics Research, EarlyView.
Based on structures of birds such as the woodpeck, this article presents the collision‐resilient aerial robot, SWIFT. SWIFT leverages tensegrity structures in the fuselage and wings which allow it to undergo large deformations in a crash, without sustaining damage. Experiments show that SWIFT can reduce impact forces by 70% over conventional structures.
Omar Aloui, Raphael Zufferey, William Stewart, Mohammad Askari, Simon Jeger, Dario Floreano   +5 more
wiley   +1 more source

Photoelastic analysis of stress generated by wires when conventional and self-ligating brackets are used: A pilot study

Dental Press Journal of Orthodontics, 2014
OBJECTIVE: By means of a photoelastic model, this study analyzed the stress caused on conventional and self-ligating brackets with expanded arch wires. METHOD: Standard brackets were adhered to artificial teeth and a photoelastic model was prepared using
Guilherme Caiado Sobral, Mário Vedovello Filho, Viviane Veroni Degan, Milton Santamaria Jr   +3 more
doaj   +1 more source

Gait Analysis of Pak Biawak: A Necrobot Lizard Built using the Skeleton of an Asian Water Monitor (Varanus Salvator)

Advanced Robotics Research, EarlyView.
Pak Biawak, a necrobot, embodies an unusual fusion of biology and robotics. Designed to repurpose natural structures after death, it challenges conventional boundaries between nature and engineering. Its movements are precise yet unsettling, raising questions about sustainability, ethics, and the untapped potential of biointegrated machines.
Leo Foulds, Donan Satria Yudha, Parvez Alam   +2 more
wiley   +1 more source

Evaluation of Antibacterial Effects of Silver-Coated Stainless Steel Orthodontic Brackets

Frontiers in Dentistry, 2016
Objectives: White spots and enamel demineralization around orthodontic brackets are among the most important complications resulting from orthodontic treatments.
Valiollah Arash, Fatemeh Keikhaee, Sayed Mahmood Rabiee, Ramazan Rajabnia, Soraya Khafri, Saeid Tavanafar   +5 more
doaj  

A Soft Robotic Device for Targeted Massage Therapy of Residual Limbs

Advanced Robotics Research, EarlyView.
Residual limb edema after amputation can hinder recovery and delay prosthetic fitting. This study presents a soft‐robotic wearable device that delivers sequential compression through pneumatic McKibben actuators. By replicating the principles of manual lymphatic drainage, the device generates controlled mechanotherapeutic pressure patterns, providing a
Maria Grazia Polizzotto, Alessio Capecchi, Maartje Van der Lingen, Emanuele Gruppioni, Arianna Menciassi, Linda Paternò   +5 more
wiley   +1 more source

A Soft Robotic Fish With a Dielectric Elastomer Actuator Body and Negative Stiffness Spine

Advanced Robotics Research, EarlyView.
This work introduces a bio‐mimetic soft robotic fish driven by fiber‐reinforced dielectric elastomer actuators integrated as its body. By prestretching this active skin against a flexible spine, a negative stiffness system is created, enabling large‐amplitude bending.
Markus Koenigsdorff, Simon Holzer, Stefania Konstantinidi, Yoan Civet, Yves Perriard   +4 more
wiley   +1 more source

3D‐Printing Aided Rapid Prototyping of Pretensioned Tensegrity Structures for Robotic Applications

Advanced Robotics Research, EarlyView.
Printing, injection molding, and assembly (PMA) is a method for rapid prototyping mesoscale, topologically complex, and tensioned tensegrity structures. In combination with PMA method, two mold design strategies: modular mold and compact channel layout, enable efficiency and scalability for tensegrity fabrication.
Yi Sun, Jan Petrš, Omar Aloui, Dario Floreano   +3 more
wiley   +1 more source

Consensus Formation and Change are Enhanced by Neutrality

Advanced Science, EarlyView.
Neutral agents are shown to enhance both the formation and overturning of consensus in collective decision‐making. A general mathematical model and experiments with locusts and humans reveal that neutrality enables robust consensus via simple interactions and accelerates consensus change by reducing effective population size.
Andrei Sontag, Janina A. Hoffmann, Tim Rogers, Christian A. Yates   +3 more
wiley   +1 more source