Sustainable optimization of drilling performance in Al6061-B<sub>4</sub>C composites: process-property interactions for lightweight engineering applications. [PDF]
Sci RepNithyananda BS +3 more
europepmc +1 more source
Enhanced Wear Resistance of Tungsten-Reinforced Brass Surface Composite Produced Through Friction Stir Processing at Varying Tool Rotational Speed. [PDF]
Materials (Basel)Alswat HM +4 more
europepmc +1 more source
Comparative Study of Surface-Coated MoS<sub>2</sub> on the Multiscale Tribological Performance of Cu-Based Composites. [PDF]
Materials (Basel)Li Y +11 more
europepmc +1 more source
Hydroxyapatite Nanoparticle Modification of 3D-Printed Crown Resin: Effects of Concentration on Surface Roughness and Vickers Hardness After Thermocycling. [PDF]
J Funct BiomaterKoç E +5 more
europepmc +1 more source
The Effect of Material Microstructures on Tool Edge Preparation of PCBN Cutting Tools. [PDF]
Micromachines (Basel)Huang Z, Wu X, Zhang C, Zhai Y.
europepmc +1 more source
Related searches:
Micro-Hardness of Irradiated Polyamide
Defect and Diffusion Forum, 2016The influence of beta radiation on the changes in the structure and selected properties (mechanical and thermal) was proved. Using high doses of beta radiation for glass fiber filled polyamide (PA) and its influence on the changes of micromechanical properties of surface layer has not been studied in detail so far.
Maňas, David +6 more
openaire +2 more sources
An instrument of simple design is described by means of which the hardness of a material at microscopically determined points on its surface can be measured. Details are given of its construction, calibration and use, together with results of some typical tests carried out with it.
H Lloyd, R Jeffrey
openaire +1 more source
Comparison of Ultrasonic-Hardness-Tester Hardness and Micro-Vickers Hardness
Japanese Journal of Applied Physics, 2007Examination methods of industrial hardnesses such as Vickers hardness and Rockwell hardness are used for the characteristic measurement of materials. These methods assume that the length of the plastic deformation is a reliable index of hardness. Since the indenters used in these methods produce deformation imprints and the methods themselves are ...
Ryoji Aoyagi, Kaoru Umezu
openaire +1 more source
Hardness and Micro-Indentation Hardness Comparison of Recycled Modified HDPE
Key Engineering Materials, 2014This research paper deals with the possible utilization of irradiated high-density polyethylene (HDPE) after its service life. Powder of recycled irradiated HDPE is used as filler into virgin low-density polyethylene (LDPE) in concentrations from 10 to 60 %. Two combinations of materials were tested granules LDPE/powder HDPE and powder LDPE/powder HDPE.
Navrátil, Jan +6 more
openaire +2 more sources
The Investigations of Surface Micro-Hardness of Experimental Hard Alloy Grades
2021The article is dedicated to evaluation of surface dynamic micro-hardness of experimental hard alloy grades with modified binder constructed on the base of standard single-carbide grade VK8. Connections between micro-hardness and absolute thermo-EMF together with thermal entropy of an alloy as integrated characteristics of its chemical composition and ...
E. V. Fominov +2 more
openaire +1 more source