Results 61 to 70 of about 76,852 (297)
A Novel Decellularized Fibrocartilage Graft Promotes Tympanic Membrane Repair
Advanced Healthcare Materials, EarlyView.An off‐the‐shelf decellularized porcine meniscus fibrocartilage graft (MEND) is engineered for pediatric tympanoplasty. Featuring a microchannel architecture that promotes host cell invasion, MEND rapidly closes tympanic membrane perforations and fully remodels in vivo, outperforming fascia and matching cartilage grafts while avoiding donor‐site ...
Paul M. Gehret +6 more
wiley +1 more source
Case Studies in Thermal EngineeringThis paper proposes a novel double-layered microchannel heat sink (TMC-ORTC), specifically, the upper layer consisted of a truncated rectangular microchannel, while the lower layer features a microchannel that combines trapezoidal cavity with oval rib ...
Bo Cai +4 more
doaj +1 more source
Advances in Mechanical Engineering, 2015 This article aims to study the impact of ribs on flow parameters and laminar heat transfer of water–aluminum oxide nanofluid with different nanoparticle volume fractions in a three-dimensional rectangular microchannel.
Omid Ali Akbari +2 more
doaj +1 more source
Quantum dot enabled thermal imaging of optofluidic devices [PDF]
, 2012 Quantum dot thermal imaging has been used to analyse the chromatic dependence of laser-induced thermal effects inside optofluidic devices with monolithically integrated near-infrared waveguides. We demonstrate how microchannel optical local heating plays
Choudhury, Debaditya +5 more
core +1 more source
Aqueous Two‐Phase Bioinks for Discrete Packing and Compartmentalization of 3D Bioprinted Cells
Advanced Healthcare Materials, EarlyView.Aqueous two‐phase systems (ATPS) enable the formation of biomimetic interfaces crucial for tissue engineering. However, clinical translation remains limited by the challenge of precisely controlling cellular compartmentalization. Here, we developed ATPS biomaterial inks for 3D bioprinting allowing tuneable droplet formation via NaCl modulation.
Martina Marcotulli +17 more
wiley +1 more source
Pressure Drop of Microchannel Plate Fin Heat Sinks
Micromachines, 2019 The entrance region constitutes a considerable fraction of the channel length in miniaturized devices. Laminar slip flow in microchannel plate fin heat sinks under hydrodynamically developing conditions is investigated semi-analytically and numerically ...
Zhipeng Duan +4 more
doaj +1 more source
Combined laser-based measurements for micro- and nano-scale transport phenomena [PDF]
, 2011 This paper was presented at the 3rd Micro and Nano Flows Conference (MNF2011), which was held at the Makedonia Palace Hotel, Thessaloniki in Greece.
3rd Micro and Nano Flows Conference (MNF2011) +2 more
core
Fluid Forces Control Structural Remodeling of Blind‐Ended Lymphatic Microvessels
Advanced Healthcare Materials, EarlyView.Using innovative microfluidic biofabrication with fluid mechanical insights, we recapitulated the blind‐ended microanatomy and physiological drainage properties of capillary lymphatics. Our results reveal the interrelationship between intra‐ and extraluminal regions of lymphatic vessels due to flow‐induced sprouting and morphological changes that ...
Jacob C. Holter +5 more
wiley +1 more source
Scientific Reports, 2022 Multiple sensors and actuators integrated in a small space, especially an elongated thin structure, require equivalent number of signal lines between microdevices, but there is limited space for signal wires.
Ayano Shimizu +3 more
doaj +1 more source
Absorption of spherical bubbles in a square microchannel [PDF]
, 2014 This paper was presented at the 4th Micro and Nano Flows Conference (MNF2014), which was held at University College, London, UK. The conference was organised by Brunel University and supported by the Italian Union of Thermofluiddynamics, IPEM, the ...
4th Micro and Nano Flows Conference (MNF2014) +4 more
core