Results 81 to 90 of about 26,276 (188)
Improved Strength and Corrosion Resistance of Ti–50Zr Alloy Through Heat Treatment
This work systematically analyzes the effects of heat treatment on mechanical properties and corrosion behavior of Ti‐50Zr alloy produced via vacuum arc melting. Microstructure transforms from coarse lamellar α phase in as‐cast condition to fine and uniformly distributes acicular α′ phase in heat‐treatment state.
Yuhua Li +7 more
wiley +1 more source
Graded refractive index (GRI) structures are prepared from the layer‐by‐layer spray coating of the mesoporous SiO2 nanoparticles, showing high solar transparency and thermal emissivity. Under outdoor conditions, after 50 days, the GRI‐coated photovoltaics show on average 6.65 ± 1.48 °C lower than that of the non‐coated references, maintaining 80.9 ± 8 ...
Heesuk Jung +14 more
wiley +1 more source
Ni–Cr–Al coarse-grained (CG) or nanograined (NC) alloys with 5 wt% Al but various Cr concentrations (10 wt% and 30 wt%) were prepared via casting and magnetron sputtering, respectively.
Xia Zhang +6 more
doaj +1 more source
In this work, a magnetic core‐shell catalyst (HOF‐on‐Fe3O4/ZIF‐67) is successfully synthesized, consisting of a metal–organic framework (ZIF‐67) with magnetic Fe3O4 as the core and a porous hydrogen‐bonded organic framework (HOF) as the shell. The catalyst efficiently activated peroxymonosulfate, resulting in rapid and effective removal of water ...
Yingying Du +4 more
wiley +1 more source
The ultraselective H2S detection of the ZIF‐L/SnS2 heterostructure is demonstrated. The introduction of 2‐dimensional (2D) breathable ZIF‐L results in a substantial increase in H2S selectivity attributable to the molecular sieving effect, which impedes the permeation of gases with large kinetic diameters and high polarity.
Soo Min Lee +7 more
wiley +1 more source
Deformation of steel chips due to machining [PDF]
Schwarz Sabine, Baumann Christian
doaj +1 more source
Protonic ceramic fuel cells offer a promising route to generate power efficiently but face critical challenges in achieving industrially viable activity and stability at their cathodes in CO2‐containing air. This report proposes a new cathode material design strategy to enable the cathode to be both catalytically active and CO2 tolerant through the ...
Desheng Feng +14 more
wiley +1 more source
This study reveals that higher shell S coordination can effectively modulate the spin state of FeN4 site via long‐range electronic interactions, giving rise to the oriented generation of singlet oxygen from peroxymonosulfate activation. Abstract Precise manipulation of coordination structure of single‐atom sites and establishment of schematic ...
Liang Zhang +8 more
wiley +1 more source
Achieving Large and Anisotropic Spin‐Mediated Thermal Transport in Textured Quantum Magnets
An advanced solvent‐cast cold pressing method is developed to synthesize highly textured quantum magnets. By aligning spin chains in Ca2CuO3 perpendicular to the pressing direction, a spin‐mediated thermal conductivity of 10 ± 1 W m⁻¹ K⁻¹ is achieved, the highest reported for polycrystalline quantum materials.
Shucheng Guo +6 more
wiley +1 more source

