Results 91 to 100 of about 6,939,509 (283)

Ti3C2Tx MXene/Silver Composite Foams For Lightweight, High‐Performance Electromagnetic Interference Shielding and Joule Heating

Advanced Materials Interfaces, EarlyView.
Ultrathin MXene/EMF composite foams achieve a specific shielding efficiency of 749.6 dB.dB·cm3$\mathrm{dB}\cdot {\mathrm{cm}}^{3}$/g, while the silver‐enhanced MXene/Ag/EMF reaches 81.4 dB shielding effectiveness at just 1.0 mm thickness. Both composites exhibit rapid Joule heating, retain stability up to 250∘C$^\circ{\rm C}$, and withstand 1000 ...
Abdullah A. Mahmood, Mingxuan Li, Vahid Rad, Mehdi Zarei, Chen‐Yu Yeh, Masoud Soroush, Guangyong Li, Paul W. Leu   +7 more
wiley   +1 more source

Controlled Synthesis of Tri‐ and Multi‐Doped Graphene

Advanced Materials Interfaces, EarlyView.
This review systematically evaluates synthesis routes for tri‐ and multi‐doped graphene, from hydrothermal and pyrolysis methods to flash Joule heating, critically assessing how each governs dopant incorporation, bonding configuration, and resulting electronic properties.
Maria Hasan, Alicja Bachmatiuk, Gražyna Simha Martynková, Karla Čech Barabaszová, Mark Hermann Rümmeli   +4 more
wiley   +1 more source

Wood‐Derived Nanocellulose‐Biocarbon Fresnel‐Zone Plate Lenses for Sub‐THz Frequency Applications

Advanced Materials Technologies, EarlyView.
Wood‐derived nanocellulose and lignin‐based biocarbon were combined to fabricate fully bio‐based Fresnel zone plate (FZP) lenses for sub‐terahertz frequencies. These sustainable FZP lenses exhibit low dielectric loss and high directivity, achieving performance comparable to that of metallic references, and remain functional under environmental stress ...
Riikka Haataja, Mikko Kokkonen, Niina Halonen, Sami Myllymäki, Umair Rafique, Mandeep Singh, Ossi Laitinen, Heli Jantunen, Kristiina Oksman, Henrikki Liimatainen   +9 more
wiley   +1 more source

Influence of Exposure Guidelines on the Design of On-Body Inductive Power Transfer [PDF]

, 2015
IEEE Wireless Power Transfer Conference, Boulder, Colorado, USA,13-15 May, 2015Designers of on-body health sensing devices with inductive power transfer (IPT) face a number of trade-offs.
Clare, Lindsay R., Worgan, Paul, Coyle, David, Salah-Eddine, Adami, Stark, Bernard H.   +4 more
core   +1 more source

Microfabrication of Soft Millirobots Propelled by Low Voltage Electrohydraulic Actuators

Advanced Materials Technologies, EarlyView.
Manual layer‐by‐layer assembly is replaced by wafer‐level MEMS batch fabrication for compliant polymer‐based electrohydraulic actuators. The microfabricated devices integrate sacrificially defined microcavities, Parylene‐C‐sealed inlets, and multilayer polymer–metal films.
Shai Shmulevich, Florian Hartmann, Herbert Shea   +2 more
wiley   +1 more source

Study of Electrical Parameters of a Low-Frequency Generator During the Formation of a Combined Discharge

Доклады Белорусского государственного университета информатики и радиоэлектроники
The article presents the results of a study examining the influence of microwave electromagnetic energy on the low-frequency component of a combined (microwave and low-frequency) discharge plasma.
M. S. Lushakova, S. I. Madveika, O. I. Tsikhan   +2 more
doaj   +1 more source

Effect of feedstock and microwave pyrolysis temperature on physio-chemical and nano-scale mechanical properties of biochar

Bioresources and Bioprocessing, 2019
Biochars were produced from softwood chips (spruce–fir mix) and hemp stalk biomasses in an in-house-developed microwave pyrolysis reactor. A kilogram batch raw biomass mixed with 10 wt% microwave absorber was pyrolyzed at 60-min residence time. Microwave
Chase A. Wallace, Muhammad T. Afzal, Gobinda C. Saha   +2 more
doaj   +1 more source

Low‐Pressure Plasma‐Based Wrinkling of PDMS and Machine Learning‐Driven Property Engineering

Advanced Materials Technologies, EarlyView.
Wrinkled surfaces are well‐suited for controlled surface deformations in the µm range. The key challenge is the relation between the resulting wrinkle features and the necessary process conditions. Machine learning techniques have solved the prediction and inverse design problems for various preparation conditions, opening a precisely controlled ...
Fabian Kopsch, Atmika Bhardwaj, Mirko Nitschke, Ilka Hermes, Andreas Fery, Anett Müller, Marco Werner, André Knapp   +7 more
wiley   +1 more source

Surrogate‐Optimized Flow‐Guided Miniature Condenser for Rapid Exhaled Glucose Detection

Advanced Materials Technologies, EarlyView.
A surrogate‐optimized miniature condenser guides humid exhaled flow toward cold surfaces to accelerate exhaled breath condensate collection. By improving vapor access within a compact footprint, the design increases sample yield. This enables post‐collection enrichment and rapid colorimetric glucose detection from dilute exhaled biomarkers within a 5 ...
Yiming Thomas Lu, Yamin Mansur, Sai Peri, Jiangyuan Wan, Amio Pronoy Das Ritwik, Emily L. Johnson, Jingcheng Ma   +6 more
wiley   +1 more source

Dynamics of Microwave Chemistry

工程科学与技术
Microwave heating of chemical reactions offers the advantages of rapid heating, high efficiency, and selective heating, contributing to energy conservation and emission reduction.
Yinhong LIAO, Tao HONG, Kama HUANG
doaj