Results 211 to 220 of about 2,318,806 (264)
Some of the next articles are maybe not open access.

Reversed nested Miller compensation with voltage follower

2002 IEEE International Symposium on Circuits and Systems. Proceedings (Cat. No.02CH37353), 2003
In this contribution we present a very efficient design approach for the frequency compensation of three-stage amplifiers using the reversed nested Miller technique. The method exploits a single voltage follower into the internal loop to remove the positive zero, avoiding the reduction of the output swing.
DI CATALDO, Giuseppe   +3 more
openaire   +2 more sources

Performance Analysis of Low Power Low Voltage Amplifier Designs in 45nm CMOS Technology by Incorporating Miller Compensation

IEEE Recent Advances in Intelligent Computational Systems, 2020
An operational amplifier designed for low power, low voltage applications based on 45nm CMOS technology with miller compensation is presented in this paper.
Lakshmy V, S. S.
semanticscholar   +1 more source

0.4-V nW-Power High-Gain Bulk-Driven Two-Stage OTA With Self-Cascode Composite Transistors and Intrinsic Current-Buffer Miller Compensation

IEEE Transactions on Circuits and Systems Part 1: Regular Papers
This paper presents a 0.4-V bulk-driven two-stage operational transconductance amplifier (OTA) achieving an exceptionally high voltage gain exceeding 120 dB without requiring additional bias voltages.
Muhammad Omer Shah   +4 more
semanticscholar   +1 more source

An OTA with Series-Cascode-Miller Compensation and Anti-Pole-Splitting for a 360-MHz BW Low-Distortion TIA in Sub-6G Broadband RF Receivers

International Symposium on Circuits and Systems
This paper presents a fully differential 2-stage operational transconductance amplifier (OTA) for a baseband transimpedance amplifier (TIA) with 360-MHz bandwidth (BW) aiming for applications in Sub-6G broadband direct-conversion receivers.
Junyao Ji   +8 more
semanticscholar   +1 more source

A High Gain 0.0831μV/mA Load Regulated Capacitorless LDO with Fast Loop and Nested Miller Compensation (NMC)

International Conference on Electronics, Information and Communications
In recent years, there has been a spike in demand for wearable devices. Low dropout regulators are an integral part of these devices, owing to their high Power Supply Rejection (PSR) and stable output.
Jayalaxmi Kiran Mukre   +4 more
semanticscholar   +1 more source

Distortion analysis of Miller-compensated three-stage amplifiers

IEEE Transactions on Circuits and Systems I: Regular Papers, 2006
This paper proposes a theoretical approach for evaluating distortion in the frequency domain of three-stage amplifiers adopting two commonly used compensation techniques, namely the nested Miller (NM) and the reversed NM. The analysis is based on appropriate amplifier modeling and on the assumption that the nonlinearity generated by each stage is ...
Cannizzaro SO   +2 more
openaire   +1 more source

Active reversed nested Miller compensation for three-stage amplifiers

2006 IEEE International Symposium on Circuits and Systems, 2006
A novel frequency compensation technique for three-stage amplifiers is introduced. Compared to the traditional reversed nested Miller compensation strategy, the proposed one exploits two active stages already included in the amplifier topology, thus no extra circuitry for its implementation is needed. The technique allows to remove the right-half-plane
A. D. GRASSO   +2 more
openaire   +2 more sources

Harmonic distortion in three-stage nested-Miller-compensated amplifiers

2004 IEEE International Symposium on Circuits and Systems (IEEE Cat. No.04CH37512), 2004
A simplified approach for evaluating high-frequency distortion of three-stage amplifiers compensated with the nested-Miller technique is presented. The analysis exploits a proper amplifier modeling and, by suitable assumptions avoids complex methods based on the Volterra series, while providing simple equations useful even for design. Besides, the most
PALUMBO, Gaetano, PENNISI, Salvatore
openaire   +2 more sources

On the power efficiency of cascode compensation over Miller compensation in two-stage operational amplifiers

Proceeding of the thirteenth international symposium on Low power electronics and design - ISLPED '08, 2008
Optimization of power consumption is one of the main design challenges in today's low-power high-speed analog integrated circuits. In this paper, two popular techniques to stabilize two-stage operational amplifiers, namely Miller and cascode compensations are compared from power point of view.
Hamed Aminzadeh, Khalil Mafinezhad
openaire   +4 more sources

A Low Power Miller Compensation Technique for Two Stage Op-amp in 65nm CMOS Technology

International Conference on Computing Communication and Networking Technologies, 2019
A critical review of the Miller compensation technique for a two-stage operational amplifier (op-amp) is presented in this paper. The trade-offs involved in the compensation capacitor value and the small signal parameters of the op-amp are also ...
R. Nagulapalli   +4 more
semanticscholar   +1 more source

Home - About - Disclaimer - Privacy