Results 101 to 110 of about 413,997 (308)
Journal of Machine EngineeringAdditively manufactured components often show insufficient component quality due to the formation of different defects. Defects such as porosity result in material inhomogeneity and structural integrity issues. The integration of in-process monitoring in
André Jaquemod +3 more
doaj +1 more source
Barkhausen Noise Emission in Milled Surfaces
Communications, 2015 This paper deals with the non-destructive evaluation of surface made of roll bearing steel 100Cr6 after milling cycles via Barkhausen noise technique.
Miroslav Neslusan +3 more
doaj +1 more source
Structural changes during milling of aluminum oxide powders [PDF]
The mechanical activation of four fused corundum powders and a calcined Al2O3 powder was studied. The milled powders were characterized by their structural properties, crystallite size, and lattice distortions. Structural changes during milling, detected
Ziepler, G.
core +1 more source
Tailoring Functional Properties of Ti–Ni–Cu Shape Memory Alloy Thin Films for MEMS Actuators
Advanced Engineering Materials, EarlyView.A comprehensive study of critical parameters required to develop well‐performing Ti–Ni–Cu thin film shape memory alloy microactuators is provided. Materials science and device integration aspects are integrated by addressing structural and physical relationships using complementary characterization techniques as well as a practical fabrication solution
Elaheh Akbarnejad +6 more
wiley +1 more source
AFM‐Based Functional Tomography – To Mill or Not to Mill, that is the Question!
Advanced Materials InterfacesThe electrical response of ferroelectric domain walls is often influenced by their geometry underneath the sample surface. Tomographic imaging in these material systems has therefore become increasingly important for its ability to correlate the surface ...
Niyorjyoti Sharma +10 more
doaj +1 more source
A New Grey Box Approach for Friction Modelling of Machine Tool Drives
Journal of Machine EngineeringMeasurement of the process force in milling is usually conducted by using piezo-electric dynamometers which are costly and reduce the stiffness of the system.
Adrian Karl Rüppel +2 more
doaj +1 more source
Creep Properties and Deformation Mechanism of Additively Manufactured NiAl‐CrMo Composites
Advanced Engineering Materials, EarlyView.Additively manufactured NiAl‐CrMo composites contain numerous interfaces and cell boundaries that control their creep response. At 700°C under high applied stress, creep is dominated by dislocation‐controlled power‐law mechanisms. At 800°C–900°C and lower stresses, creep is primarily diffusion‐controlled along cell boundaries.
Jan Vollhüter +9 more
wiley +1 more source
Frontier Materials & TechnologiesStudy of the temperature field of the milling process with the imposition of ultrasonic vibrations (USV), under various ratios of the vibration amplitude to the depth of tooth penetration into the blank, will allow predicting the efficiency of the ...
Aleksandr N. Unyanin +2 more
doaj +1 more source
ADAPTIVE NEURO-FUZZY INFERENCE SYSTEM FOR END MILLING [PDF]
Journal of Engineering Science and Technology, 2016 Soft computing is commonly used as a modelling method in various technological areas. Methods such as Artificial Neural Networks and Fuzzy Logic have found application in manufacturing technology as well. NeuroFuzzy systems, aimed to combine the benefits
ANGELOS P. MARKOPOULOS +3 more
doaj