Results 341 to 350 of about 3,060,710 (350)

Modeling of the instantaneous milling force per tooth with tool run-out effect in high speed ball-end milling

International Journal of Machine Tools and Manufacture, 2017
exaly  

Plane surface milling force prediction with fillet end milling cutter under pre-determined inclination angle

The International Journal of Advanced Manufacturing Technology, 2019
Z. C. Wei, Shuying Li, M. Guo, Jiaxin Wang, S. Liu   +4 more
semanticscholar   +1 more source

A generic tool wear model and its application to force modeling and wear monitoring in high speed milling

Mechanical Systems and Signal Processing, 2019
Kunpeng
exaly  

An analytical force model with shearing and ploughing mechanisms for end milling

International Journal of Machine Tools and Manufacture, 2002
exaly  

Evaluation of Milling Force Constants in Different Milling Type Processes

Nhu-Tung Nguyen, Xuan-Hai Le, Ngoc-Linh Nguyen, Thanh-Phuong Vu, Van-Hai Nguyen, Van-Phong Le   +5 more
openaire   +1 more source

Determination of the chip geometry, cutting force and roughness in free form surfaces finishing milling, with ball end tools

International Journal of Machine Tools and Manufacture, 2003
exaly  

Experimental studies of cutting force variation in face milling

International Journal of Machine Tools and Manufacture, 2011
exaly  

Experimental Analysis of Milling Force Pulsation

Precision Engineering, 1991
openaire   +1 more source

Modeling micro-end-milling operations. Part I: analytical cutting force model

International Journal of Machine Tools and Manufacture, 2000
exaly  

Prediction of cutting force distribution and its influence on dimensional accuracy in peripheral milling

International Journal of Machine Tools and Manufacture, 2002
exaly