Results 31 to 40 of about 2,791,295 (349)
Applied Sciences, 2022 Understanding the influence of the main cutting force energy consumption of the milling cutter is the basis for prediction and control of energy and machining efficiency.
Bin Jiang +3 more
doaj +1 more source
Tool Deflection Control by a Sensory Spindle Slide for Milling Machine Tools [PDF]
, 2017 A conventional spindle slide of a milling center is enhanced to a force "feeling" component for process monitoring and control tasks. The feeling ability is realized by integrating strain gauges in notches machined into the structure.
Boujnah, Haythem +2 more
core +2 more sources
Cutting Forces during Inconel 718 Orthogonal Turn-Milling [PDF]
Materials, 2021 Inconel 718 is a material often used in the aerospace and marine industries due to its properties and ability to work in harsh environments. However, its machining is difficult, and therefore methods are sought to facilitate this process. One of such methods is turn-milling.
Agata Felusiak-Czyryca +3 more
openaire +2 more sources
The International Journal of Advanced Manufacturing Technology, 2022 With the development of the aviation manufacturing industry, the application range of thin-walled parts is rapidly increasing. Accurate machining process and surface topography prediction are the keys to ensuring machining quality.
Xia Li, Y. Gong, Jibin Zhao
semanticscholar +1 more source
A novel milling force model based on the influence of tool geometric parameters in end milling
Advances in Mechanical Engineering, 2018 A novel milling force model for cutting aviation aluminum alloy 7075 using carbide end mill is established in this article. A two-dimensional end-milling model is set up to investigate the influence of tool geometric parameters on milling force with the ...
Xianglei Zhang +4 more
doaj +1 more source
Micro-Milling Tool Wear Monitoring via Nonlinear Cutting Force Model
Micromachines, 2022 Mechanistic cutting force model has the potential for monitoring micro-milling tool wear. However, the existing studies mainly consider the linear cutting force model, and they are incompetent to monitor the micro-milling tool wear which has a ...
Tongshun Liu, Qian Wang, Weisu Wang
doaj +1 more source
Effect of High Speed Milling Process Parameters on the Milling Force and Surface Topography of AM50A Magnesium Alloy [PDF]
Xibei Gongye Daxue Xuebao, 2018 Within the scope of high speed milling process parameters, analyzed and discussed the effects of spindle speed, feed rate, milling depth and milling width on milling forces in the process of high speed milling of AM50A magnesium alloy.
doaj +1 more source
Applied Sciences, 2022 Carbon fiber-reinforced composites (CFRP) are widely used in aerospace structural holes due to their superior mechanical properties. However, fiber pulling, delamination, burr and other defects often occur in the parts, which seriously affect the ...
Changhong Wang +3 more
doaj +1 more source
Key mechanistic features of swelling and blistering of helium-ion-irradiated tungsten [PDF]
, 2019 Helium-ion-induced swelling and blistering of single-crystal tungsten is investigated using a Helium Ion Microscope for site-specific dose-controlled irradiation (at 25 keV) with analysis by Helium Ion Microscopy, Atomic Force Microscopy and Transmission
Allen, FI, Balooch, M, Hosemann, P
core +2 more sources
Instantaneous rigid force model based on oblique cutting to predict milling force
Nihon Kikai Gakkai ronbunshu, 2017 In end milling, in order to improve machining efficiency and accuracy, instantaneous rigid force model is widely used to predict cutting force and improve cutting conditions.
Kazuki KANEKO +3 more
doaj +1 more source