Results 51 to 60 of about 256,076 (285)
Advanced Engineering Materials, EarlyView.Excellent combinations of strength and impact toughness are obtained in a bilayer composite of high‐strength carbide‐free bainitic (CFB) steel and high‐ductility twinning‐induced plasticity (TWIP) steel. The composite absorbs energy at small strains when the notch is placed on the TWIP side and at high strains when the notch is placed on the CFB side ...
Kendra Hawke +5 more
wiley +1 more source
npj Materials SustainabilityBiochar-iron based material has been recognized as an important soil and underground water remediation material, which successfully achieves by adsorption, reduction, and mediating advanced oxidation.
Hangyu Li +6 more
doaj +1 more source
Fabrication Material Zeolite Modified by Fe with Treatment and Without High Energy Milling on Zeolite Materials [PDF]
, 2015 Natural zeolite in Indonesia are generally found in bulk form and many impurities. The purpose of this research was obtaining iron modified zeolite with and without High Energy Milling treatment on zeolite material.
Grafiana, Nur Farida +2 more
core
Advanced Engineering Materials, EarlyView.The release of foulers from protective marine coatings is determined by several interrelated material properties, including the strength of Young's modulus, the flexibility of chain segments, the surface free energy, and the magnitude of hydrodynamic stress.
Johann C. Schaal +2 more
wiley +1 more source
Machines, 2023 A series of experiments were performed aiming at controlling milling force-induced surface errors in the robot-assisted milling process, for the sub-area of the multi-stiffener reinforced inner wall of complex cylindrical thin-walled casting parts, to ...
Yongqiao Jin +3 more
doaj +1 more source
Reusable neoprene jacket protects parts for chemical milling [PDF]
, 1965 Reusable neoprene jacket is used to prepare metal part or panel for chemical milling. Jacket covers back and upper rim of part and is sealed before the masking solution is applied to surface to be milled.
core +1 more source
The effect of an organic pentasulfide EP additive in turning and milling operations [PDF]
, 2014 Coopération avec Ecole Centrale LyonBecause a cutting fluid could be equally used for different cutting operations, this study proposed to investigate the behavior of a well-known extreme-pressure additive (pentasulfide) in both turning and milling ...
BIERLA, Aleksandra +4 more
core +4 more sources
Rheocasting versus Die Casting: An Insight into the Low‐Cycle Fatigue Behavior of AlSi7Mg0.6
Advanced Engineering Materials, EarlyView.The study compares rheocast lightweight components with high‐pressure die cast materials regarding microstructure and fatigue behavior. Rheocast process offers higher efficiency due to lower casting temperatures. Despite some microstructural differences, both processes show similar strengths (yield strength 125 MPa, tensile strength 240 MPa).
Julia Richter +4 more
wiley +1 more source
Frontiers in Materials, 2022 Several studies investigating the ball-milling of ductile face-centered cubic metals have reported a so-called in-situ consolidation phenomenon where the milled powder is also consolidated during the milling process.
Sara I. Ahmad, Khaled M. Youssef
doaj +1 more source
Advanced Engineering Materials, EarlyView.This study proposes a new methodology for producing metal matrix nanocomposites in the solid state. The process involves the plasma‐assisted thermochemical treatment of metallic alloy powders. As a proof‐of‐concept, TiN nanoparticles are synthesized directly on the surface of FeTi intermetallic powder particles, enabling the development of the ...
Deivison Daros Paim +4 more
wiley +1 more source