Results 211 to 220 of about 485,064 (256)
Some of the next articles are maybe not open access.
Research on load monitoring technology of mine hoist based on machine vision
Measurement science and technologyA hoist load monitoring method based on machine vision technology is proposed in this paper to address the frequent overloading accidents of mine hoists and the low safety and reliability of existing contact load monitoring technologies.
Zuzhi Tian +4 more
semanticscholar +1 more source
Failure analysis of a mine hoist rope
Engineering Failure Analysis, 1997Abstract An extensive investigation was carried out to determine the cause of the early retirement of an in-service hoist rope. The rope was retired earlier than expected because it met the criteria for removal based on the number and distribution of wire breaks.
K. Schrems, D. Maclaren
openaire +1 more source
Conveyance monitoring to improve mine hoisting safety
IAS '97. Conference Record of the 1997 IEEE Industry Applications Conference Thirty-Second IAS Annual Meeting, 2002Technology to enhance safety during mine hoisting is being investigated by researchers at the Spokane Research Center National Institute for Occupational Safety and Health, USA. The objective is to test sensor technology and engineering controls to prevent injuries and fatalities related to vertical movement of personnel and materials in mine shafts ...
M.J. Beus, T.M. Ruff, W.G. McCoy
openaire +1 more source
The Problem of Stability in Mechanical Systems Using the Example of Mine Hoist Installations
Applied SciencesInvestigating the influence of varying shaft steelwork stiffness on the stability of horizontal mass displacements, which are crucial elements of a conveyance-shaft steelwork system, is a significant step in evaluating the risk of parametric vibrations ...
Agata Drzewosz, Stanisław Wolny
semanticscholar +1 more source
Improvement of Mine Hoisting Equipment Upgrade
Applied Mechanics and Materials, 2014The coal mine hoisting equipment is one of the most important equipmentin coal mine, largely determine the total production capacity of the mine. Compared with the international advanced level, there is a considerable gap between the many coal mine enterprises, especially the plate chain bucket elevator is more big gap.On the upgrading of equipment for
openaire +1 more source
Hybrid-hoists for ultra deep-level mines
1999 IEEE Africon. 5th Africon Conference in Africa (Cat. No.99CH36342), 2003Hybrid-hoists have been proposed as a possible solution for ultra deep-level hoists. The hybrid hoist consists of a combination of a conventional hoist and a linear motor. Instead of the entire load being supported by the hoisting rope, the linear motor will take up most of the work during times when peak stresses would usually be placed on the rope ...
R.J. Cruise, C.F. Landy
openaire +1 more source
Vision-based 2D Vibration Displacement Measurement of Hoisting Vertical Rope in Mine Hoist
Proceedings of the 2020 3rd International Conference on Artificial Intelligence and Pattern Recognition, 2020In this paper, a non-contact, unmarked computer vision measurement method is presented and applied to measure the two-dimensional (2D) vibration displacement of hoisting vertical ropes. In this method, the primary work is to perform camera calibration of monocular vision using a neural network (NN) model.
Ganggang Wu, Xingming Xiao, Chi Ma
openaire +1 more source
Fatigue Life Analysis of Mine Hoist Drum
Advanced Materials Research, 2014This article is based on a certain type of hoist drum, Moreover, we make the stress and mode analysis for the drum, and make preliminary check on it. Then find the position of the weak section, we calculate the force in each stage of hoisting system and draw force-timing load spectrum,we translate it into stress function of weak link.
Xia Peng, Xian Sheng Gong
openaire +1 more source
Mechanics based design of structures and machines, 2020
The main shaft device (MSD) is a key component of the mine hoisting system. During lifting, vibration of the system will cause dynamic tension of wire rope at both ends, resulting in the complex stress state at the critical location of the MSD and thus ...
Shuang Cao +4 more
semanticscholar +1 more source
The main shaft device (MSD) is a key component of the mine hoisting system. During lifting, vibration of the system will cause dynamic tension of wire rope at both ends, resulting in the complex stress state at the critical location of the MSD and thus ...
Shuang Cao +4 more
semanticscholar +1 more source
A New Electric Mine Hoist at Butte, Montana
Transactions of the American Institute of Electrical Engineers, 1917A description of equipment in connection with a recent Ilgner-Ward Leonard hoist installation at the Elm Orlu Mining Company, Butte, Montana. This installation is one of the two largest of this type in operation in this country. Complete data on two sets of tests; the first conducted to analyze a typical day's run and the second to determine efficiency
openaire +1 more source