Results 121 to 130 of about 1,410,672 (282)
Advanced Engineering Materials, EarlyView.The formation of nonmetallic inclusions (NMIs) was investigated in this study, carrying out immersion tests for 30 min at a temperature of 1600°C with liquid high‐silicon electrical steel (Si ≈ 3 mass‐%) and different MgO–C refractories. Conventional MgO–C refractories were considered, as well as MgO–C refractories containing MgO–C recyclate and ...
Lukas Neubert +6 more
wiley +1 more source
Seed quality and storage performance in mungbean and peanut : a thesis presented in partial fulfilment of the requirement for the degree of Master of Agricultural Science in Seed Technology, at Massey University, Palmerston North, New Zealand [PDF]
, 1996 Five seedlots of mungbean and three seedlots of peanut were assessed for seed quality using six standard laboratory tests ie. purity analysis, seed moisture content, germination, seed health, and two vigour tests (accelerated ageing, and conductivity ...
Supradith, Uraiwan
core
Advanced Engineering Materials, EarlyView.This study investigates laser‐based oxide removal of Cu inserts in oxygen‐free conditions and examines long‐term oxidation kinetics and surface chemistry under different atmospheres via X‐ray photoelectron spectroscopy. Al–Cu compound casting with differently oxidized surfaces is performed, and intermetallic phase formation, morphology, and thermal ...
Timon Steinhoff +9 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.The wettability of aluminum droplets (Al) on different copper substrates (Cu), where liquid Al spreads on solid Cu surfaces to form a liquid–solid interface, is studied numerically and experimentally. The experimental and numerical results show good agreement in the fast‐spreading regime.
Shan Lyu +8 more
wiley +1 more source
Moisture movement in bulk stockpiles [PDF]
, 1995 Both drainage and evaporation are possible mechanisms for moisture loss in iron-ore and coal stockpiles. Some simple models are used to study both these mechanisms for various stages of stockpiling.
Fulford, G., McElwain, S.
core
Advanced Engineering Materials, EarlyView.EDX elemental map of the pre‐oxidized MgO–steel cermet anode cross section after electrolysis. The development of inert anodes for aluminum electrolysis remains challenging due to the high corrosivity of cryolite‐based melts at 950°C–1000°C. This study investigates the corrosion and process behavior of a carbon‐free MgO–steel cermet anode derived from ...
Alexander Adamczyk +7 more
wiley +1 more source
Advanced Engineering Materials, EarlyView.Micro‐Raman spectroscopy is applied to characterize corrosion products in a recycled‐based MgO–316L steel composite anode after molten salt electrolysis. A depth‐dependent Fe–O/Fe–Al–O layer sequence of magnetite, hercynite, and an Al‐doped magnetite transition zone is identified.
Felix Drechsler +9 more
wiley +1 more source
Moisture Measurement in Materials by the Equilibrium Method
Measurement + Control, 1970 Kurd G. Groeninger
doaj +1 more source
Shipin gongye ke-jiIn this paper, the highland barley moisture, β-glucan, amylopectin and protein content rapid detection model was established based on the 4000~10000 cm−1 near-infrared spectrum and actual contents of 76 highland barleys.
Yanting YANG +7 more
doaj +1 more source