Results 71 to 80 of about 2,097 (212)
Location and chemical composition of microbially induced phosphorus precipitates in anaerobic and aerobic granular sludge [PDF]
, 2012 This work focuses on combined scanning electron microscopy and energy dispersive X-ray analysis (SEM-EDX) applied to granular sludge used for biological treatment of high-strength wastewater effluents. Mineral precipitation is shown to occur in the core
Biscans, Béatrice +3 more
core +4 more sources
Development of surgical techniques in craniofacial reconstruction [PDF]
, 2016 Introduction: Facial fractures are common and either the injury or the surgical treatment may cause sequelae including diplopia, visual loss, dystopia, enophthalmos, scarring, soft tissue affection and sensory disturbances.
Neovius, Erik
core +1 more source
Engineering the Immune Response to Biomaterials
Advanced Science, Volume 12, Issue 19, May 22, 2025.This paper reviews immune responses to biomaterials, stages of evolution in relation to managing these responses ranging from preventing to modulating them. It also discusses state‐of‐the‐art strategies to modulate these responses and modes of their delivery.
Abolfazl Salehi Moghaddam +12 more
wiley +1 more source
The Hydrothermal Synthesis of 1D Biomedical Hydroxyapatite Nanostructures [PDF]
, 2014 Poster presented at the 16th Annual Conference of the Materials Research Society of Serbia - YUCOMAT 2014, Herceg Novi, Montenegro, September 1–5 ...
Ignjatović, Nenad +4 more
core +3 more sources
Ionic liquid-assisted formation of cellulose/calcium phosphate hybrid materials
Beilstein Journal of Nanotechnology, 2014 Cellulose/calcium phosphate hybrid materials were synthesized via an ionic liquid-assisted route. Scanning electron microscopy, transmission electron microscopy, energy-dispersive X-ray spectroscopy, X-ray diffraction, infrared spectroscopy, and ...
Ahmed Salama +3 more
doaj +1 more source
Effect of Processing on Structural and Morphological Changes of Hydroxyapatite‐Based Materials
ChemistrySelect, Volume 10, Issue 14, April 11, 2025.The low‐cost wet precipitation method produces fine needle‐like, hexagonal hydroxyapatite (∼10, 20 nm, crystallite, and 20 m2/g). Calcination increases crystallite size (50 nm), reduces surface area, alters morphology to rounded agglomerates, and changes symmetry to triclinic.
L. Klecandová +9 more
wiley +1 more source
fabrication of electrospun dicalcium phosphate anhydrous and chitosan based scaffolds [PDF]
, 2014 Dicalcium phosphate anhydrous (DCPA) powder was synthesized in the size range between 200- 750 nm using calcium carbonate and phosphoric acid in ethanol solution.
Lipsita, S
core
Three-dimensional printing of porous load-bearing bioceramic scaffolds [PDF]
, 2017 This article reports on the use of the binder jetting three-dimensional printing process combined with sintering to process bioceramic materials to form micro- and macroporous three-dimensional structures.
Alharbi NA. +32 more
core +3 more sources
Advanced NanoBiomed Research, Volume 5, Issue 3, March 2025.The study explores 3D‐printed scaffolds combining PEOT/PBT polymer with βTCP particles coated in Zn/Cu or Zn/Co ions at two concentrations (low [L] and high [H]). These scaffolds enhance osteogenic differentiation, collagen production, and angiogenic properties, particularly at low Zn/Co concentrations, demonstrating the potential for bone regeneration
Martyna Nikody +5 more
wiley +1 more source
Surface properties of biomimetic nanocrystalline apatites; applications in biomaterials [PDF]
, 2014 Several types of nanocrystalline apatites have been described, obtained in various ways. Among these, biomimetic nanocrystalline apatites (BNA), whose characteristics are close to those of biological apatites, have been shown to exhibit specific ...
Brouillet, Fabien +6 more
core +4 more sources