Results 81 to 90 of about 7,602 (296)
Investigating the Low‐Temperature Phase Stability of the Binary Ta–W System
Atomistic simulations show that the binary Ta–W system forms ordered intermetallic phases, B2‐TaW and D03‐TaW3, as 0 K ground states. Configurational entropy, however, lowers the free energy of the disordered bcc solid solution, which becomes the stable phase above about 400 K.
Klemens Lechner +7 more
wiley +1 more source
HEA interlayers offer a versatile route for joining high‐performance structural materials. Their compositional and structural design regulates interfacial reactions, suppresses brittle IMCs, and improves metallurgical bonding. Sandwich interlayers further integrate defect healing with precipitation strengthening, enabling improved strength–ductility ...
Lin Yuan +4 more
wiley +1 more source
In this research, okra fiber was extracted from okra plants by the biological degradation method. Cellulosic okra fibers were treated with sodium carbonate, and then the samples were dyed with natural dye obtained from madder with different ...
Seyda Eyupoglu +3 more
doaj +1 more source
Effects of Mg on Microstructure and Solidification of a Hypereutectic Zn–8 wt.%Al Alloy
An appreciable set of results involving thermal data, microstructure, chemical composition, and microstructural growth laws is reported for ZnAlMg alloys. Such results demonstrate that ZnAlMg alloys have high potential for applications in automotive self‐lubricating components, batteries, and electrical systems.
Raí B. de Sousa +6 more
wiley +1 more source
Near‐surface deuterium enrichment profiles for different microstructural types of TiAl after exposure at 700 °C in a heavy water‐containing environment. The deuterium levels are significantly higher than expected from natural occurrence, indicating that the heavy water dissociated during the exposure treatment and entered the specimens.
Jonathan D. H. Paul +5 more
wiley +1 more source
Assessment of Dyeing Properties of Hibiscus sabdariffa on Ostrich Leather
Natural dyestuffs derived from various plants can be used for dyeing processes in the textile and leather industries. Hibiscus sabdariffa, one of these natural dyestuffs, is known to be used in textiles and produces a red color with good dyeing ...
Nilay Örk Efendioğlu +2 more
doaj +1 more source
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe +6 more
wiley +1 more source
Utilization of Tamarind Seeds Extract as a Natural and Sustainable Fabric Dye
This research focuses on the use of tannin components in tamarind seed coats as a mordant and natural dye in cotton fabrics. Tannins were extracted from the tamarind seed coat by boiling method and then the tannin content was determined.
Astri Nur Istyami +7 more
doaj
The Optimized Analysis of the Dyeing Property of Coptis Chinensis towards Natural Bamboo Fiber
The paper researches the dyeing property of coptis chinensis and bamboo fiber through orthogonal experimental analysis and single factor comparative analysis, gets the optimized process of direct dyeing, pre- mordant dyeing, one-bath dyeing and post ...
Hong Chen, Mohan Zhang, Hong Liu
doaj +1 more source
Despite benefits to storage stability and handleability of aluminum scrap, octadecyl phosphonic acid (ODPA) SAMs reduce the tensile strength of wires produced using friction‐induced recycling. Etching and methyl diphosphonic acid (MDPA) coatings, however, have little effect.
Timothy D. Goller +3 more
wiley +1 more source

