Results 11 to 20 of about 106,612 (245)
Biodegradable materials as binders for IVth generation moulding sands [PDF]
China Foundry, 2015 This paper focuses on the possibility of using the biodegradable materials as binders (or parts of binders?compositions) for foundry moulding and core sands.
K. Major-Gabry
doaj +1 more source
Powder co-injection moulding [PDF]
, 2000 A novel powder processing technique has been developed by combining conventional powder injection moulding with polymer co-injection moulding, to permit the in-situ surface engineering of metal or ceramic components as an integral step within the ...
Hanson, S. M. J.
core +7 more sources
Biodegradable materials as foundry moulding sands binders [PDF]
Metalurgija, 2015 The aim of this article is to show the possibility of using biodegradable materials as part of the composition of foundry moulding and core sand binders.
K. Major - Gabryś
doaj +2 more sources
Development tendencies of moulding and core sands [PDF]
China Foundry, 2011 Further development of the technology for making moulding and core sands will be strictly limited by tough requirements due to protection of the natural environment.
Stanislaw M. Dobosz1 +2 more
doaj +1 more source
Large Section Ceramic Injection Moulding [PDF]
, 2000 PhDCeramic injection moulding is already established as a production technique for complex shaped ceramic components. However the process is limited to thin section mouldings generally not exceeding a wall thickness of 10 mm.
Krug, S., Krug, Steffen
core +4 more sources
Thermal transfer simulation regarding the rotational moulding of polyamide 11 [PDF]
, 2013 Simulation of thermal phenomena in rotational moulding is very important to follow the evolution of the temperature in various zones of this process. It was a question of modelling heat gradients developing in rota-tional moulding part.
TCHARKHTCHI, Abbas +2 more
core +1 more source
Archives of Foundry Engineering, 2015 Modern techniques of castings production, including moulding sands production, require a strict technological regime and high quality materials. In the case of self-hardening moulding sands with synthetic binders those requirements apply mainly to sand ...
Dobosz St. M. +3 more
doaj +1 more source
Archives of Foundry Engineering, 2015 The paper presents the results of basic research on the influence of the properties of sand grains on electrical properties of water glass moulding sands.
Opyd B., Granat K.
doaj +1 more source
Effects of Moisture and Content of Moulding Sand Bentonite on the Electric Properties [PDF]
Archives of Metallurgy and Materials, 2018 The paper presents the results of laboratory tests into the effects of moisture and the content of two types of bentonite on dielectric properties of moulding sand.
D. Nowak
doaj +1 more source
Effect of Matrix Type on Properties of Moulding Sand with Barley Malt [PDF]
Archives of Foundry EngineeringThe aim of the following work was to determine the possibility of using barley malt as a binder in moulding sands technology. The moulding sands prepared on the basis of three kinds of sands, i.e. quartz, olivine and chromite sands were analyzed.
B. Samociuk, D. Nowak, D. Medyński
doaj +1 more source