Results 231 to 240 of about 27,236 (261)
Some of the next articles are maybe not open access.
Solitonic Signals Generation and Transmission Using MRR
2015The advantage of the study is that nonlinear behavior of light inside ring resonators system can be controlled and managed by using appropriate parameters of the microring resonator (MRR) system. The effects of the coupling coefficients on the bifurcation and chaos behaviors, in terms of roundtrip and output powers are presented.
Iraj Sadegh Amiri, Harith Ahmad
openaire +1 more source
Influence of Workpiece Shape on MRR and EWR in EDM of Steel
Advanced Materials Research, 2014Shape of workpiece, electrode orientation and flushing system play important role in electrical discharge machining (EDM) process. Low material removal rate and relatively high electrode wear ratio are some of the disadvantages of EDM process. This can be due to the flushing modes. Workpiece shape has a significant effect in effectiveness of dielectric
Alexis Mouangue Nanimina +4 more
openaire +1 more source
Notch Filters based on Multilayer Ring Resonators (MRR)
2019 IEEE 19th Mediterranean Microwave Symposium (MMS), 2019Notched band filters are proposed based on multilayer ring resonator (MRR) structures. Three methods are introduced to obtain notch response for both forward-coupling and reverse-coupling configurations. In the first technique, an extra loop is employed on the top or bottom layer of MRR filters and a stop band is generated.
openaire +1 more source
Analysis of single Micro-Ring Resonators (MRR), add/drop filter MRR and cascaded MRR
2016Iraj Sadegh Amiri +2 more
openaire +1 more source
A Novel Approach for Modeling MRR in EDM Process Using Utilized Discharge Energy
Mechanical Systems and Signal Processing, 2023Nirmal Kumar Singh +2 more
exaly
Investigation of MRR and surface characterization using plasma process
Materials and Manufacturing Processes, 2023Hari Narayan Singh Yadav +4 more
openaire +1 more source
Voxel-Based Analysis and Modeling of MRR Computational Accuracy in Milling Process
CIRP Journal of Manufacturing Science and Technology, 2019Roby Lynn, Zhenguo Nie, Tommy Tucker
exaly

