Results 41 to 50 of about 4,075 (189)
ABSTRACT To address the dual challenges of routine driving vibration and impact loads in vehicle seat suspensions, a novel variable‐gap magnetorheological damper (VGMRD) is proposed. By combining a tapered piston with a conformal variable‐diameter cylinder, stroke‐dependent, dual‐mode damping characteristics are achieved without the need for complex ...
Min Wei +4 more
wiley +1 more source
Design, Modeling, and Vibration Control of a Damper Based on Magnetorheological Fluid and Elastomer
The aim of this study is to propose a damper based on magnetorheological (MR) fluid and elastomer for application in vehicle engine mounting systems to dissipate the vibration energy transferred from the engine to the vehicle body.
Zhuang Jin +4 more
doaj +1 more source
Transient conformal TEHL algorithms for multibody simulation [PDF]
This article describes aspects of transient thermal elasto-hydrodynamical lubrication (TEHL) contact modelling for conformal contacts. This is to be utilized in a multibody simulation (MBS) framework for engineering purposes.
Dag Fritzson
doaj +1 more source
Linear Mechatronic Modeling of Rectangular Tank Sloshing Dynamics
ABSTRACT Sloshing dynamics in partially filled tanks can strongly influence system‐level behavior when fluid motion couples with rigid‐body dynamics. This paper presents a linear and acausal two‐dimensional sloshing model for rectangular tanks, based on the reformulation of established sloshing theory within a modular, multi‐domain modeling framework ...
Magnus Steinstø, Eilif Pedersen
wiley +1 more source
ED-FNN: A New Deep Learning Algorithm to Detect Percentage of the Gait Cycle for Powered Prostheses
Throughout the last decade, a whole new generation of powered transtibial prostheses and exoskeletons has been developed. However, these technologies are limited by a gait phase detection which controls the wearable device as a function of the activities
Huong Thi Thu Vu +5 more
doaj +1 more source
ABSTRACT This paper proposes a hybrid control strategy for flexible‐link manipulators that combines offline trajectory planning with adaptive tracking to suppress residual elastic vibration (REV) under unknown bounded disturbances. A rigid–flexible coupling dynamics model is first established using the floating‐frame method and Lagrange's equations ...
Mingming Shi +5 more
wiley +1 more source
ABSTRACT Vibration isolation has long been a critical area of research, with the design of isolators based on the mechanical properties of Euler buckling beams representing one of the primary approaches. Traditionally, the focus has been on utilizing the negative stiffness characteristics of a post‐buckled Euler beam in parallel with positive stiffness
Yichang Feng +3 more
wiley +1 more source
The CYBERLEGs Beta-Prosthesis is an active transfemoral prosthesis that can provide the full torque required for reproducing average level ground walking at both the knee and ankle in the sagittal plane. The prosthesis attempts to produce a natural level
Louis Flynn +9 more
doaj +1 more source
ABSTRACT The operational reliability of thermal control circulation pumps is significantly restricted by the multi‐physics coupled environment. To reveal the vibration transmission mechanisms and dynamic response characteristics under multi‐field coupled excitations, a multi‐DOF coupled dynamic representation of the overall system, incorporating the ...
Jianfeng Luo +4 more
wiley +1 more source
Integrating Grain to Ground Motion Data for Critical Rock Bridge and Slope Failure Analysis
ABSTRACT Rock masses can fail catastrophically with little warning, yet their stability depends on hidden internal connections that channel forces and localise damage. Among these, rock bridges–a “known unknown” in slope mechanics–lock fractured rock and control how failure unfolds, but their concealed geometry and uncertain strength obscure where and ...
Antoinette Tordesillas +5 more
wiley +1 more source

