Results 71 to 80 of about 23,005 (233)
Control design for an under-actuated UAV model [PDF]
FME Transactions, 2018 Unmanned Aerial Vehicles (UAV), are increasingly being adapted and used in civil contexts, with particular specialization in the monitoring of the territory for environmental purposes, civil protection or possibly control and inspection of inaccessible ...
De Simone M.C., Guida D.
doaj
Design of a Large Deployable Reflector Opening System
Machines, 2020 Large Deployable Reflectors (LDR) are receiving considerable attention from aerospace government companies and researchers. In this paper, the design of the opening system of a LDR is presented.
Alessandro Cammarata +4 more
doaj +1 more source
CAAI Transactions on Intelligence Technology, EarlyView.ABSTRACT Accurate surface‐pressure prediction over broad operating envelopes is critical for supersonic aerodynamic analysis and design. To overcome the bottlenecks of traditional computational fluid dynamics (CFD) in real‐time performance and computational efficiency, data‐driven deep learning methods have emerged. However, existing data‐driven models
Hongbin Xu, Yin Long, Junlin Wu
wiley +1 more source
Unraveling authoritarian reform decision‐making: A metacognitive–subcognitive model
American Journal of Political Science, EarlyView.Abstract Recent research indicates that state reforms in East and Southeast Asia have been predominantly top‐down and authoritarian‐led. However, this significant observation implicitly relies on important assumptions about authoritarian decision‐making behavior and psychology that remains understudied.
Eugene Yu Ji
wiley +1 more source
Research on Dynamic Modeling and Control of Magnetorheological Hydro-Pneumatic Suspension
ActuatorsA novel magnetorheological semi-active hydro-pneumatic suspension system was proposed to overcome the shortcoming of the traditional hydro-pneumatic suspension without adaptive vibration damping function. It is based on the magnetorheological semi-active
Yuansi Chen +6 more
doaj +1 more source
Applied Sciences, 2020 The aim of this paper is to present an explicit analytical biomechanical multibody procedure able to be implemented in the solution of the musculoskeletal systems inverse dynamics problems.
Alessandro Ruggiero, Alessandro Sicilia
doaj +1 more source
Standing on a common ground: a comparison of static stability approaches for pallet loading
International Transactions in Operational Research, EarlyView.Abstract At the practical level, the static stability constraint is one of the most important constraints in practical pallet loading problems, such as air cargo palletizing. Approaches to modeling static stability, which range from base support and mechanical equilibrium calculations to physical simulation, differ in workflow, focus, and assumptions ...
Philipp G. Mazur +3 more
wiley +1 more source
Washing Machine Dynamic Model to Prevent Tub Collision during Transient State
Sensors, 2020 In horizontal-axis washing machines, the front gasket as well as the damping system are crucial owing to the possible collision of the tub with the housing during the transient period.
Beatriz Sánchez-Tabuenca +4 more
doaj +1 more source
Wind Energy, Volume 29, Issue 7, July 2026.ABSTRACT Physics‐based design optimization workflows thread the needle between computational cost limitations and simulation complexity, often compromising between modeling detail and the range of operating design conditions. Multipoint aerostructural optimization of wind turbine rotors has so far been confined to low‐fidelity analyses or to high ...
Marco Mangano +5 more
wiley +1 more source
Enhancing UAV elevator actuator model using multibody dynamics simulation [PDF]
INCAS BulletinThis paper proposes an improved actuator system model for UAV elevators using multibody dynamics simulation. The multibody dynamics simulation employs the Simscape Multibody, module in MATLAB coupled with Simulink to model the servo and hinge moment ...
Akhmad Farid WIDODO +3 more
doaj +1 more source