Results 61 to 70 of about 18,960 (304)

General questions of anaesthesiology [PDF]

open access: yes, 2015
This book covers information about basic principles and methods of the modern anesthesiology.
Ohiienko, Maksym Mykolaiovych   +8 more
core  

Microplastics from Wearable Bioelectronic Devices: Sources, Risks, and Sustainable Solutions

open access: yesAdvanced Functional Materials, EarlyView.
Bioelectronic devices (e.g., e‐skins) heavily rely on polymers that at the end of their life cycle will generate microplastics. For research, a holistic approach to viewing the full impact of such devices cannot be overlooked. The potential for devices as sources for microplastics is raised, with mitigation strategies surrounding polysaccharide and ...
Conor S. Boland
wiley   +1 more source

Facet joint osteoarthritis as a cause of chronic low back pain

open access: yesНеврология, нейропсихиатрия, психосоматика, 2019
Chronic nonspecific low back pain (LBP) is the most common cause of disability and a lower quality of life in modern society.Objective: to discuss the feasibility of identifying the causes of chronic nonspecific LBP and in the case of detection of damage
D. O. Rozhkov   +3 more
doaj   +1 more source

Centrally acting skeletal muscle relaxants and associated drugs

open access: yesJournal of Pain and Symptom Management, 1994
A review of available studies supports a role for muscle relaxants in the treatment of painful musculoskeletal disorders. The utility of these drugs is limited by sedation and other side effects, as well as by the potential for abuse and dependency.
openaire   +2 more sources

Educating Radiologists About Pain [PDF]

open access: yes, 2016
It is vital that radiologists understand pain. After all, it is the most common symptom that leads patients to seek medical care, and represents one of the most common indications for diagnostic and interventional radiological procedures 1, 2 and 3.
Fogler, Brian D., Gunderman, Richard B.
core   +1 more source

Photo‐Switching Thermal and Lithium‐Ion Conductivity in Azobenzene Polymers

open access: yesAdvanced Functional Materials, EarlyView.
Light‐responsive azobenzene polymers control thermal and ionic transport simultaneously through structural transitions. UV illumination disrupts π–π stacking, converting crystalline trans states to amorphous cis configurations. Thermal conductivity drops from 0.45 to 0.15 W·m−1·K−1 while Li+ diffusivity increases 100 fold. This dual transport switching
Jaeuk Sung   +7 more
wiley   +1 more source

Ten Years of Experience Training Non-Physician Anesthesia Providers in Haiti. [PDF]

open access: yes, 2009
Surgery is increasingly recognized as an effective means of treating a proportion of the global burden of disease, especially in resource-limited countries. Often non-physicians, such as nurses, provide the majority of anesthesia; however, their training
AF Ouro-Bang’na Maman   +31 more
core   +2 more sources

Interconnected Porous Hydrogels with Tunable Anisotropy Through Aqueous Emulsion Bioprinting

open access: yesAdvanced Functional Materials, EarlyView.
A 3D bioprintable microporous bioink is developed using an aqueous two‐phase system (ATPS) composed of extracellular matrix (ECM) mimetic biopolymers. The ATPS bioink enables the fabrication of interconnected porous architectures with up to 70% porosity, supporting long‐term cell viability and 3D cell alignment, enabling a simultaneous generation of ...
Hugo Edgar‐Vilar   +4 more
wiley   +1 more source

Caudal Peridural Anesthesia in Neonates: A Safe Alternative for the Anesthesiologist

open access: yesRevista Cubana de Anestesiología y Reanimación, 2020
 Introduction: Regional anesthesia and analgesia techniques in the pediatric population guarantee hemodynamic and respiratory stability. The use of caudal anesthesia has increased enormously, especially for lower abdominal surgeries, which offers ...
Alexis Ramón Pineda González   +2 more
doaj  

Adaptive 4D‐Printed Vascular Stents With Low‐Temperature‐Activated and Intelligent Deployment

open access: yesAdvanced Functional Materials, EarlyView.
Microarchitected coronary artery stents were fabricated using a polycaprolactone (PCL)‐based shape memory polymer (SMP) composite via projection micro‐stereolithography (PµSL) 4D printing. By incorporating diethyl phthalate (DEP) as a plasticizer, the thermal transition temperature (Ttran) was modulated to about 37°C, enabling rapid and autonomous ...
Yannan Li   +12 more
wiley   +1 more source

Home - About - Disclaimer - Privacy