Results 11 to 20 of about 811 (96)
ANALYSIS OF THE AXIAL GAP VS FIBERBOARD MOISTURE CONTENT IN A 9975 SHIPPING PACKAGE [PDF]
, 2013 The fiberboard assembly within a 9975 shipping package contains a modest amount of moisture, which can migrate to the cooler regions of the package when an internal heat load is present.
Daugherty, W.
core +1 more source
Use of human hair fiber as a reinforcement in a cement fiberboard [PDF]
, 2023 In Partial Fulfillment of the Requirements for the Degree Bachelor of Science in Civil EngineeringHuman hair is a waste that needs to be disposed of properly since this waste has an unlimited supply and will take time to decompose. Proper utilization and
Maravillas, Abbey Gayl +2 more
core +1 more source
Understanding the Adhesion Mechanism in Mycelium-Assisted Wood Bonding
, 2021 The increasing environmental awareness has led to an increased interest in developing more sustainable materials as alternatives to petroleum-derived products.
Sun, Wenjing
core
Castor Oil Based Polyurethane Resin Used in the Production of Medium Density Fiberboard [PDF]
, 2020 The medium density fiberboard (MDF) is a wood derived product. The wood-based panel is normally produced with urea-formaldehyde, melamine-formaldehyde and/or phenol-formaldehyde adhesives.
Nascimento +5 more
core
, 2011 To study the impact of VDP on the bending process of fiberboard, this paper deeply researched into the dynamic changes of section stress distribution of fiberboard during the process of loading and bending and built a static bending strength predicting ...
Yang Zhang, Zhi Ming Yu
core +1 more source
Cross-Linked Chitosan as an Eco-Friendly Binder for High-Performance Wood-Based Fiberboard
, 2021 High-performance wood-based fiberboards with high strength and dimensional stability were fabricated by hot-pressing method using 2,5-dimethoxy-2,5-dihydrofuran (DHF) cross-linked chitosan (CS) as an eco-friendly binder.
Yutao Yan +5 more
core +1 more source
Hot-pressing process modeling for medium density fiberboard (MDF) [PDF]
, 2001 We present a numerical solution for the mathematical modeling of the hot-pressing process applied to medium density fiberboard. The model is based on the work of Humphrey (1982), Humphrey and Bolton (1989), and Carvalho and Costa (1998) with some ...
Storti, Mario Alberto +3 more
core +1 more source
Mechanical Property Data for Fiberboard [PDF]
, 2004 The 9975 shipping package incorporates a cane fiberboard overpack for thermal insulation and impact resistance. Mechanical properties (tensile and compressive behavior) have been measured on cane fiberboard and a similar wood-based product following ...
WILLIAM, daugherty
core
The use of borax pentahydrate of inorganic filler in medium density fiberboard production
, 2021 The aim of the study was the use of the inorganic borax pentahydrate mineral in medium density fiberboard production instead of biomass fiber and to specify the performance which physical, mechanical, combustion of produced boards.
Osman Çamlıbel +4 more
core +1 more source
Influence of moisture on the performance of polyethylene coated solid fiberboard and boxes [PDF]
, 2010 Effects of moisture on the mechanical properties of one commercial solid fiberboard grade and on the compression strength of mill-fabricated transport boxes made from this material were studied.
Paunonen, Sara
core