Results 11 to 20 of about 3,405 (198)
IET Power Electronics, EarlyView., 2023 This study introduces a new modular multilevel inverter that can produce five levels of positive voltage using only six power switches and five DC voltage sources. The basic unit is composed of a single‐ and double‐source (SDS) unit. SDS reduces the number of power electronic components, such as the insulated gate bipolar transistors, freewheeling ...
Naser Fakhri +4 more
wiley +1 more source
A nine‐level T‐type inverter (9L‐TTI) with voltage boost capability
IET Power Electronics, EarlyView., 2023 A new multi‐level inverter topology with boosting feature considering the reduced switch count has been presented, compared and validated. Abstract This paper introduces a 9L T‐type boost inverter (9L‐TTI) based multilevel topology, which generates a nine‐level output voltage in the boost mode.
Zarren Firdous +5 more
wiley +1 more source
A three‐phase three‐level converter with shared flying capacitors
IET Power Electronics, EarlyView., 2023 Three‐phase multilevel converters use a high number of components which increases their size. As specific weight reduction is a work of interest for embedded system applications, this paper presents a topology aiming to optimize volume and mass for a three‐level three‐phase inverter. The number of passive and active components is reduced thanks to the ‘
Maxime Pain +2 more
wiley +1 more source
IET Power Electronics, EarlyView., 2023 The proposed TB‐SCMLI is able to provide seven levels of output voltage by balancing the voltage of two capacitors with the given control logic. The various SCMLIs are evaluated to determine the contribution of the suggested TB‐SCMLI topology's merits and downsides.
Md. Reyaz Hussan +4 more
wiley +1 more source
IET Power Electronics, EarlyView., 2023 An innovative switched‐capacitor‐based inverter is proposed in this article. The suggested converter can produce a five‐level output voltage by utilizing minimal components (single dc source, six switches, and one capacitor). The effectiveness of the suggested inverter is verified by experimental results using hardware in loop OPAL‐RT OP4510.
Tamiru Debela +2 more
wiley +1 more source
IET Power Electronics, EarlyView., 2023 This paper proposes a new Double T‐type H‐bridge (DTH) module configuration that can produce 9, 13, 17, 19, 21, and 25 levels using reduced components. Abstract Renewable energy sources are subject to input source uncertainties, which can negatively impact output voltage THD.
Omid Zolfagharian +2 more
wiley +1 more source
Energies, 2022 The Reduced Asymmetric Neutral Point Clamped converter topology for unipolar driven, multiphase switched reluctance machines is proposed in this paper. This topology shares similarities with the conventional NPC and Asymmetric-NPC topologies, however it ...
Pieter Antonie Scholtz +1 more
doaj +1 more source
IEEE Access, 2021 This paper introduces an advanced space vector modulation technique for three-level neutral-point-clamped (3L-NPC) converters. The studied 3L-NPC converters within aircraft electric starter generator (ESG) systems normally operate at high modulation ...
Chen Li +5 more
doaj +1 more source
IEEE Access, 2021 This paper presents an integrated single-phase bidirectional ac–dc converter based on a dual-active-bridge (DAB) topology. The primary side is based on a multi-state switching cell (MSSC) with a T-type (TNPC) cell, which is composed of two three ...
Welton da S. Lima +6 more
doaj +1 more source
IEEE Access, 2023 The neutral-point-clamped (NPC) dual-active-bridge (DAB) converter with hybrid semiconductors (Si and SiC devices) is a promising topology for high-power energy storage systems.
Jiaxin Dong +5 more
doaj +1 more source