Results 51 to 60 of about 23,134 (270)
1D and 3D Carbon Nanomaterials Derived from Zeolite‐Based Catalysts: Synthesis and Applications
Small Structures, EarlyView.Zeolites act as catalysts or catalytic templates to synthesize 1D and 3D carbon nanomaterials with uniform structures, enabled by their high surface area and uniform porous frameworks. The resulting carbon nanomaterials possess excellent surface area and electronic conductivity, supporting their use in energy storage, catalysis, electronics, gas ...
Kulika Pithaksinsakul +3 more
wiley +1 more source
Non-Infiltrating Angiolipoma of Floor of Mouth-A Rare Case Report and Literature Review [PDF]
Journal of Clinical and Diagnostic Research, 2017 Angiolipoma, a subtype of lipoma is a benign tumour in which adipose tissue and vascular component are intermingled. The tumour occurs commonly in the trunk and extremities and very rarely seen in maxillofacial region.
SANAT KUMAR BHUYAN +3 more
doaj +1 more source
Where Can Aluminum Go When Batteries Die?
Advanced Science, Volume 13, Issue 7, 3 February 2026.Battery‐derived aluminum is transformed from contaminated waste into an alloying resource for high‐performance Fe‐based alloys. Through controlled Al content and processing, dual‐phase austenite/ferrite microstructures with TRIP‐like behavior are achieved.
Raymond Kwesi Nutor +3 more
wiley +1 more source
Materials Research Letters, 2017 The Cu and NiAl nanoscale precipitation and interfacial segregation in the martensite and austenite phases within a high-strength steel were studied by atom-probe tomography (APT).
Z. B. Jiao +4 more
doaj +1 more source
Applied Sciences, 2016 The deformation behavior and fracture characteristics of NiAl intermetallic alloy containing 5~7 at% Cu are investigated at room temperature under strain rates ranging from 1 × 10−3 to 5 × 103 s−1.
Tao-Hsing Chen, Jian-Hong Wu
doaj +1 more source
npj Materials Degradation, 2023 A dense NiAl coating with low oxide content was deposited on the GH4202 superalloy substrate by atmospheric plasma spraying (APS) using carbon-containing Ni/Al composite powders.
Li Zhang +5 more
doaj +1 more source
Materials Science and Engineering: A, 1998 Abstract We have investigated texture evolution in stoichiometric NiAl and Ni-49at.%Al–1at.%Ti using orientation imaging microscopy (OIM) and X-ray diffraction. Grain size and orientation were studied after extrusion and after heat treatment, leading to the following model of texture evolution.
Department of Mechanical Engineering, FAMU-FSU College of Engineering, Tallahassee, FL 32306, USA ( host institution ) +3 more
openaire +2 more sources
Advanced Science, Volume 13, Issue 6, 30 January 2026.This study develops a lightweight AlFeNiTiV complex concentrated alloy (density: 6.83 g cm−3) through Cu microalloying and lattice coherency tuning. The alloy exhibits ultrahigh compressive strength exceeding 3.3 GPa, 11.8% strain, and retains a yield strength of 1311.6 MPa at 600 °C, demonstrating a phase interface strategy for high‐temperature ...
Hongmei Chen +10 more
wiley +1 more source
Review of Financial Economics, Volume 44, Issue 1, January 2026.Abstract This paper introduces a three‐factor interest rate risk model to improve the measurement of active bond fund performance. Traditional models assume a linear relationship between risk exposure and expected returns, leading to biases. By incorporating level, slope, and curvature factors derived from Treasury index returns, the proposed model ...
Martin Rohleder
wiley +1 more source
Проблеми трибологіїThis article examines the impact of adding phosphorus to NiAl intermetallic powder on the structure, microhardness, and tribological properties of plasma-sprayed coatings, which are suitable for use under dry friction conditions.
T. Levchuk +3 more
doaj +1 more source