Results 161 to 170 of about 1,167,763 (204)
Earliest evidence for systematic use of ultrahigh carbon steel in the ancient Aegean in the Archaic Milesia. [PDF]
Güder Ü +3 more
europepmc +1 more source
One-Pot High-Current-Density Electrodeposition of Ni-Ce and Ni-Fe-Ce Catalysts on Bamboo-Derived Carbon Fabric for Alkaline Water Splitting. [PDF]
Lee SW, Ahn S.
europepmc +1 more source
openaire +1 more source
Some of the next articles are maybe not open access.
Related searches:
Related searches:
Influence of Casting Defects on the Fatigue Limit of Nodular Cast Iron
International Journal of Fatigue, 2004The high cycle fatigue behaviour of a nodular cast iron has been investigated under tension loading. Casting defects are at the origin of crack initiation for all samples tested. Critical defects (shrinkage) are located either at the surface or within the bulk.
Y Nadot, N Ranganathan, J Méndez
exaly +2 more sources
Effect of Alloying on Mechanical Properties of as Cast Ferritic Nodular Cast Irons [PDF]
The development of low temperature applications for ferritic nodular cast irons calls for improved materials in the as cast state, e.g. for off-shore windmills components.
Jacques Lacaze, Jon Sertucha, R Suarez
exaly +2 more sources
SAE Technical Paper Series, 1950
<div class="section abstract"><div class="htmlview paragraph">NODULAR cast iron, so called because the graphite is present as finely dispersed, well-rounded particles, is made in two stages:</div><div class="htmlview paragraph">The first stage consists of the addition of magnesium or other carbide formers, which promote the ...
Gosta Vennerholm +2 more
openaire +1 more source
<div class="section abstract"><div class="htmlview paragraph">NODULAR cast iron, so called because the graphite is present as finely dispersed, well-rounded particles, is made in two stages:</div><div class="htmlview paragraph">The first stage consists of the addition of magnesium or other carbide formers, which promote the ...
Gosta Vennerholm +2 more
openaire +1 more source
Automotive Ductile (Nodular) Iron Castings
2017This SAE standard covers the minimum mechanical properties measured on separately cast test pieces of varying thickness and microstructural requirements for ductile iron castings used in automotive and allied industries. Castings may be specified in the as-cast or heat-treated condition.
+5 more sources
Plate Fracture of Nodular Cast Iron
Key Engineering Materials, 2010Plate fracture is a defective fracture structure in nodular cast iron that can be found especially in the transition area of feeder, feeder neck and the cast part itself. It occurs rather spontaneously due to the fact that the exact reason for it is still unknown.
C.J. Heckmann, W. Stets, G. Wolf
openaire +1 more source
The Flow and Fracture of Nodular Cast Iron
Journal of Fluids Engineering, 1957Abstract Combined stress tests on pearlitic nodular iron show this material possesses a constant valued modulus of elasticity and Poisson’s ratio. The maximum shear criterion for yielding is conservative, but is sufficiently accurate for design purposes.
W. R. Clough, M. E. Shank
openaire +1 more source
Deformation and failure in nodular cast iron
Acta Materialia, 2012Abstract Ductile failure in nodular cast iron is explored through uniaxial tension and notched tension experiments. Specimens obtained through tests interrupted at various stages of deformation and failure evolution were examined through quantitative microscopy to discern the mechanisms of failure and to quantitatively evaluate the local strain ...
A. Ghahremaninezhad, K. Ravi-Chandar
openaire +1 more source

