Results 141 to 150 of about 14,858,985 (276)
Effects of Mg on Microstructure and Solidification of a Hypereutectic Zn–8 wt.%Al Alloy
An appreciable set of results involving thermal data, microstructure, chemical composition, and microstructural growth laws is reported for ZnAlMg alloys. Such results demonstrate that ZnAlMg alloys have high potential for applications in automotive self‐lubricating components, batteries, and electrical systems.
Raí B. de Sousa +6 more
wiley +1 more source
Introduction to the solidification of metals
The table of contents for this item can be shared with the requester. The requester may then choose one chapter, up to 10% of the item, as per the Fair Dealing provision of the Canadian Copyright ActMonograph on metallurgy and the solidification of ...
Institute of Metals, Winegard, W.C.
core +1 more source
Near‐surface deuterium enrichment profiles for different microstructural types of TiAl after exposure at 700 °C in a heavy water‐containing environment. The deuterium levels are significantly higher than expected from natural occurrence, indicating that the heavy water dissociated during the exposure treatment and entered the specimens.
Jonathan D. H. Paul +5 more
wiley +1 more source
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe +6 more
wiley +1 more source
Two different experiments were conducted with German chamomile grown according to conventional and organic farming systems. Flower (drug) and shoot yields were determined, and their essential (Fe, Zn, Mn and Cu) and non-essential heavy metal (Pb, Ni, Co, Cr and Cd) contents were measured and the results were compared according to treatments: control ...
Esetlili, Bihter Colak +3 more
openaire +3 more sources
This study proposes a potential device design for joint cartilage replacement. Silica‐polytetrahydrofuran (SiO2‐PolyTHF) hybrids with customizable mechanical properties were developed to mimic the characteristics of a natural meniscus. These were synthesized through a two‐pot sol–gel hybrid process.
Yu‐Chien Lin +12 more
wiley +1 more source
Essential and non-essential metals in children's intellectual functioning: A multi-media biomarker approach from a Mexico City birth cohort. [PDF]
Florez-Garcia VA +6 more
europepmc +1 more source
Despite benefits to storage stability and handleability of aluminum scrap, octadecyl phosphonic acid (ODPA) SAMs reduce the tensile strength of wires produced using friction‐induced recycling. Etching and methyl diphosphonic acid (MDPA) coatings, however, have little effect.
Timothy D. Goller +3 more
wiley +1 more source
Quantitative distribution of essential elements and non-essential metals in breast cancer tissues by LA-ICP-TOF-MS. [PDF]
Escudero-Cernuda S +7 more
europepmc +1 more source
Elastic–Plastic Modeling and Experimental Characterization of Granular Jamming Actuators
Granular jamming enables rapid switching between soft and rigid mechanical states. Here, a reduced‐order elastic‐perfectly‐plastic beam framework captures pressure‐dependent loading, unloading, residual deformation, and hysteresis in jammed beams, while matching three‐point bending experiments across materials and geometries. The framework links design
Saheli Patel +2 more
wiley +1 more source

