Results 41 to 50 of about 35,665 (238)
Global and Detailed Calculation of Tube Wall Temperature in a Process Furnace Steam Superheater
This study presents a comparison between an iterative global model and multiple approaches to a new non‐iterative model with the purpose of predicting tube wall temperature of a superheater. The results show that the non‐iterative method achieves sufficient accuracy while improving the prediction of local temperature distribution and better ...
Anežka Michálková, Zdeněk Jegla
wiley +1 more source
The combustion processes are characterised by two non linear feedback mechanisms producing self-acceleration. One is of a thermal nature and the other is purely chemical.
Clavin, Paul +3 more
core +1 more source
In small-scale combustors, the ratio of area to the combustor volume increases and hence heat loss from the combustor’s wall is significantly enhanced and flame quenching occurs.
Seyed Ehsan Hosseini +3 more
doaj +1 more source
Abstract NOx emissions from gas boilers severely impact the environment, and flue gas recirculation (FGR) technology can effectively reduce such emissions, yet the effects of different FGR rates on combustion performance and NOx formation remain unclear. This study thus used numerical simulation (via ANSYS Fluent, adopting the realizable k‐ε turbulence
Chao Min +3 more
wiley +1 more source
This study is dedicated to improving the efficiency of the flamelet-generated manifold (FGM) tabulated chemistry combustion modeling approach for predicting the combustion process in diesel-ignited internal combustion (IC) engines.
Marija Stipic +3 more
doaj +1 more source
Key improvements obtained by incorporating nanoparticles into a lab‐scale SAGD process configuration. The bar plots show enhanced oil recovery, reduced viscosity, and increased asphaltene adsorption in nanoparticle‐assisted scenarios compared with conventional SAGD.
Luis Prada +6 more
wiley +1 more source
Development of novel laser diagnostic techniques for the quantitative study of premixed flames
The main topic of this thesis concerns the development and application of laser diagnostic techniques for accurate temperature measurements and for the determination of flamefront properties in premixed flames that can serve as input data for ...
core +1 more source
Study on the Combustion Behavior of Inhomogeneous Partially Premixed Mixtures in Confined Space
Reasonably configuring the concentration distribution of the mixture to achieve partially premixed combustion has been proven to be an effective method for improving energy utilization efficiency.
Yanfei Li +3 more
doaj +1 more source
Ignition and flame propagation phenomenon of dieselfuel combustion was investigated in an optical single cylinder engine. Conventionalnon-premixed diesel combustion and partially premixed combustion types were investigated.Experiments were performed on ...
Cengizhan Cengiz +4 more
doaj +1 more source
Large Eddy Simulation Of Non-Premixed Combustion With Detailed Chemistry
Poster presented at the XXXIX Meeting of the Italian Section of the Combustion ...
Shamooni, Ali +2 more
openaire +2 more sources

