Results 131 to 140 of about 67,775 (286)
ABSTRACT This study addresses limitations of the conventional dry‐pressing method for electrolyte‐supported films—smooth surfaces, excessive thickness, and fragile supports inducing damage. We propose an innovative camphor–quartz sand composite architecture to construct a five‐layer (camphor/quartz sand/YSZ/quartz sand/camphor) system, enabling thin ...
Hong Chang +8 more
wiley +1 more source
To achieve successful 3D concrete printing, meticulous control of the digital manufacturing process is essential, involving the precise management of mechanical components and the use of high-quality materials.
Jin Soo Bang, Hong Jae Yim
doaj +1 more source
Nondestructive evaluation of advanced ceramics [PDF]
A review is presented of Lewis Research Center efforts to develop nondestructive evaluation techniques for characterizing advanced ceramic materials.
Kautz, Harold E., Klima, Stanley J.
core +1 more source
Langley Research Center Standard for the Evaluation of Socket Welds [PDF]
A specification utilized for the nondestructive evaluation of socket type pipe joints at Langley Research Center (LaRC) is discussed. The scope of hardware shall include, but is not limited to, all common pipe fittings: tees, elbows, couplings, caps, and
Berry, R. F., Jr.
core +1 more source
A Review of Transient Characterization Techniques for Quantum Dot Light‐Emitting Diodes
This review surveys transient characterization techniques for quantum dot light‐emitting diodes, including TRPL, TREL, TA, and E‐TA. These methods resolve carrier‐selective dynamics across multiple time scales, enabling direct analysis of charge injection, exciton formation and recombination, efficiency roll‐off, and device degradation.
Jaekwon Kim +5 more
wiley +1 more source
“A simple 1D transfer matrix model of a battery is introduced and parametrized using harvested individual cell components at 0 % and 100 % SoC. This model allows for the calculation of group velocity and attenuation. The results of the model show good agreement with measured values, highlighting increased attenuation and group velocity at the ...
Simon Feiler +3 more
wiley +1 more source
Fabrication and characteristics of experimental radiographic amplifier screens [PDF]
The fabrication process and transfer characteristics for solid state radiographic image transducers (radiographic amplifier screens) are described. These screens are for use in realtime nondestructive evaluation procedures that require large format ...
Szepesi, Z.
core +1 more source
Affinity Peptides With pH Sensitivity for the Enrichment of CD38+ Cells
ABSTRACT The selective enrichment of cell populations based on surface markers is critical for the advancement of gene and cell therapies. Current antibody‐based cell isolation methods, such as fluorescence‐ and magnetic‐activated cell sorting (FACS and MACS), offer high specificity but are limited by scalability, cost, and potential adverse effects on
Gabrielle Rusch +7 more
wiley +1 more source
This review presents a comprehensive summary and discussion of some optimization strategies for enhancing room‐temperature ionic conductivity of Na3Zr2Si2PO12 (NZSP) solid electrolyte for solid‐state sodium batteries, including foreign‐ion doping or substitution, sintering behavior modulation, and regulation of chemical composition based on precursors.
Jiawen Hu +5 more
wiley +1 more source
Mid‐Infrared Spectroscopy and Machine Learning for Chlorogenic Acid Quantification in Coffee
Chlorogenic acid (CGA) concentration in coffee was predicted using mid‐infrared (MIR) spectroscopy and a machine learning approach. Forty‐four roasting stages (140–220 °C) plus a green coffee control were analyzed. A multilayer perceptron regressor, trained on preprocessed MIR data, outperformed traditional peak analysis, enabling accurate and ...
Deborah Herdt +6 more
wiley +1 more source

