Results 31 to 40 of about 421,125 (270)
Energies, 2021 This article reports the results of a study into the effect of operating parameters on the occurrence and course of gas–liquid two-phase phenomena during the fogging process carried out with the use of a conical pressure-swirl nozzle.
Waldemar Fedak +9 more
doaj +1 more source
Flow characteristics of a round jet with divergent and convergent tapered annulus
Nihon Kikai Gakkai ronbunshu, 2014 The flow characteristics of round air jets with tapered annulus was investigated experimentally. The divergent and convergent tapered annulus was installed concentrically inside of the round nozzle.
Taichi USUZAWA +2 more
doaj +1 more source
Evaluation on the Performance of Automobile Engine Using Air Injection Nozzle in the Intake Manifold
Energies, 2021 In the present study, a nozzle was used to improve the flow performance of an intake manifold, and its effects on the automobile engine output and the exhaust gas were experimentally studied.
Taejung Kim +3 more
doaj +1 more source
Investigation of Flow Characteristics inside a Dual Bell Nozzle with and without Film Cooling [PDF]
Aerospace Science and Technology, 2020, 2021 In this study, we perform a two-dimensional axisymmetric simulation to assess the flow characteristics and understand the film cooling process in a dual bell nozzle. The secondary stream with low temperature is injected at three different axial locations on the nozzle wall, and the simulations are carried out to emphasize the impact of injection ...
arxiv +1 more source
Evaluation of the efficiency of cleaning dental plaque on titanium using a cavitating jet
Journal of Biomechanical Science and Engineering, 2014 Dental plaque, which adheres to the surfaces of dental implants and remains in the gingival crevices, can cause peri-implantitis, which is similar to periodontal disease; consequently, cleaning the dental plaque from these surfaces is very important.
Mariko KIKUCHI +4 more
doaj +1 more source
Characterization of the Nozzle Ablation Rate Based on 3D Laser Scanning System
Aerospace, 2023 The nozzle of solid rocket motor (SRM) is easily ablated by high temperature, high pressure, high speed, and corrosive particles, which affects the stability of rocket flight.
Kaining Zhang +3 more
doaj +1 more source
Breakup characteristics of diesel spray droplets under small valve opening injection
Nihon Kikai Gakkai ronbunshu, 2016 A laser 2-focus velocimeter (L2F) was used for measurements of velocity and size of droplets in diesel fuel sprays. Diesel fuel was injected intermittently into the atmosphere using a 8-hole injector nozzle. The diameter of the nozzle orifice was 0.112mm.
Noritsune KAWAHARADA +3 more
doaj +1 more source
Fluids, 2023 Reduction of energy expenditures required for various technological processes is a pressing issue in today’s economy. One of the ways to solve this issue in regard to liquefied natural gas (LNG) storage is the recovery of its vapours from LNG tanks using
Victor Bolobov +2 more
doaj +1 more source
Nozzle contours for minimum particle-lag loss [PDF]
, 1963 The flow of a gas-particle mixture through a rocket nozzle is analyzed under the approximation that the particle slip velocity is small compared with the average mixture velocity, using one-dimensional gasdynamics, the Stokes drag law, and corresponding ...
Marble, Frank E.
core +1 more source
Lab on a Chip, 2019 Step emulsification is an attractive method for production of monodisperse drops. Its main advantage is the ability to parallelize many step emulsifier nozzles to achieve high production rates.
Elad Stolovicki, R. Ziblat, D. Weitz
semanticscholar +1 more source