Results 41 to 50 of about 112,854 (317)
Modeling of Vegetable Oil Miscellaneous Drive Process in Final Distiller Spray Zone
Proceedings of the International Conference on Applied Innovations in IT, 2023 This work discusses the kinetics of the separation process of a solution consisting of vegetable oil and a low-boiling hydrocarbon solvent in a distillation process.
Abduhoshim Qadirov +4 more
doaj +1 more source
Experimental investigation of the inflection geometry on dual bell nozzle flow behavior
, 2011 The altitude adaption of the dual bell nozzle is achieved by the contour inflection, leading to a symmetrical and controlled separation under sea level conditions.
Ralf Stark +3 more
core +1 more source
Journal of Fluid Science and Technology, 2013 This report aims to clarify the relationship between the preferred frequency and jet diffusion. The disturbance frequency used to control mixing, based on the preferred frequency of a flow in the initial area of the jet column mode, is often selected ...
Yuki KAWAI, Motoaki KIMURA
doaj +1 more source
Numerical Modelling of the Multiphase Flow in an Agricultural Hollow Cone Nozzle
Applied SciencesIn the field of agriculture, various types of pesticides are used to control crop pests. These chemical agents are applied using nozzles with different geometries.
Paweł Karpiński +2 more
doaj +1 more source
Similarity Law on Shedding Frequency of Cavitation Cloud Induced by a Cavitating Jet
Journal of Fluid Science and Technology, 2012 In order to clarify the mechanism of cavitation cloud shedding, the shedding frequencies of cavitation clouds were investigated by high-speed observations and image analysis. The results indicate that the shedding frequency follows the similarity law for
Satoshi NISHIMURA +2 more
doaj +1 more source
Advanced Engineering Materials, EarlyView.Low‐cycle fatigue damage in Mn–Mo–Ni reactor pressure vessel steel is examined using a combined electron backscatter diffraction and positron annihilation lifetime spectroscopy approach. The study correlates texture evolution, dislocation substructure development, and vacancy‐type defect formation across uniform, necked, and fracture regions, providing
Apu Sarkar +2 more
wiley +1 more source
Mathematical model of foam expansion rate generated in sprinklers
Magazine of Civil EngineeringFoam solution discharge is always accompanied by changes in the operating pressure due to different pressure losses along the pipeline in automatic foam extinguishing systems.
Kamluk Andrei +3 more
doaj +1 more source
Lance Design for Scrap Melting Aggregates
Tehnički Glasnik, 2021 Metallurgical aggregates, which are used for metal waste melting, are equipped with lances for blowing gaseous media. These gaseous media allow especially scrap melting and intense homogenization of the resulting melt.
Ladislav Kovar, Pavel Novak, Tomas Hapla
doaj
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
Advanced Engineering Materials, EarlyView.A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Mechanical Engineering Journal, 2016 Output increase of combined cycle power plants is highly expected in order to deal with tight supply-demand situation of electricity and to save fuel consumption.
Shuichi UMEZAWA, Katsuhiko SUGITA
doaj +1 more source