Results 1 to 10 of about 5,719,643 (296)
Numerical Analysis of the Pile-Grout System in Soft Clay under Vertical and Lateral Load [PDF]
In this paper, a numerical investigation of the effects of grout parameters on the load response of concrete pile-grout systems in soft clay is presented.
Qaddoory Khalid I. +2 more
doaj +1 more source
Based on 35-year (1981–2015) ensemble (24 members) hindcasts of the IAP/LASG global seasonal prediction system named FGOALS-f2 V1.0 (FGOALS-f2), the tropical cyclone (TC) seasonal prediction skills over the South China Sea (SCS) during the TC peak season
Jinxiao Li +9 more
doaj +1 more source
Numerical Investigation of a Dynamic Stall on a Single Rotating Blade
Dynamic stall is a phenomenon on the retreating blade of a helicopter which can lead to excessive control loads. In order to understand dynamic stall and fill the gap between the investigations on pitching wings and full helicopter rotor blades, a ...
Yin Ruan, Manfred Hajek
doaj +1 more source
A series of numerical simulation were conducted to study the local scour around umbrella suction anchor foundation (USAF) under random waves. In this study, the validation was carried out firstly to verify the accuracy of the present model.
Ruigeng Hu +4 more
doaj +1 more source
The energy consumption of data center cooling systems accounts for a large proportion of total energy consumption. The optimization of airflow organization is one of the most important methods to improve the energy efficiency of cooling systems.
Hongyin Chen +7 more
doaj +1 more source
The pipe jacking method is gradually attracting increasing levels of attention and is becoming an important method for constructing underground engineering.
Minglei Ma +4 more
doaj +1 more source
Numerical Investigation of Blast Furnace Operation with Scrap Charging
One approach to reduce CO2 emission in the steelmaking industry is to recycle scrap to the blast furnace/basic oxygen furnace (BF/BOF) production system. This paper performed a numerical investigation on the BF operation with scrap charging.
Zhu Liu +4 more
doaj +1 more source
In the present work the analysis of three different width ratio of twisted tape in a shell and tube heat exchanger done by ANSYS FLUINT14.0. Heat exchanger type shell and tube have been widely used in industrial application such as refrigeration and ...
Najim Abid Jassim +2 more
doaj +1 more source
Heat transfer and pressure drop through mono and hybrid nanofluid‐based photovoltaic‐thermal systems
Using nanofluids in photovoltaic‐thermal systems enhances the overall efficiency; however, increasing the pressure drop and pumping power, because of the higher viscosity of nanofluids, is a challenging factor for the nanofluid‐based systems.
Mohsen Hormozi Moghaddam, Maryam Karami
doaj +1 more source
The current work presents and discusses a numerical analysis of improving heat transmission in the receiver of a parabolic trough solar collector by introducing perforated barriers.
Tayeb Fahim +6 more
doaj +1 more source

