Results 91 to 100 of about 26,302,580 (302)
Sustainability assessment requires methodologies that appropriately distinguish between additive and non‐additive material properties. A toxicity‐weighted scoring system is developed and applied that accounts for the disproportionate influence of highly toxic constituents through nonlinear weighting functions, providing more realistic estimates than ...
Seth Mehalic +2 more
wiley +1 more source
A Novel Approach to Estimate the Transition Temperature via Dynamic Nanoindentation
A new dynamic nanoindentation‐based method was developed that uses the stiffness ratio as an indicator of the elastic–plastic deformation contributions at different temperatures. The approach successfully identified transition temperatures in ferritic steel and distinguished them from continuously ductile austenitic steel.
Stefan Zeiler +4 more
wiley +1 more source
To enhance through‐thickness conductivity without sacrificing impregnation, large spherical graphite particles are intentionally employed in a low‐viscosity resin. Unlike finer conductive fillers, these particles remain outside the fiber bundles and accumulate in resin‐rich interlaminar regions during molding.
Keito Hosoe +6 more
wiley +1 more source
Half title: Talks about paper.Manufacture of soda and sulphite pulp / by Thomas J. Keenan. --Manufacture of coated paper / by Alexander Thomson. -- Manufacture of printing plates / by S.H. Horgan. -- Lithographing / by J.F. Boyd. -- Inks / by J. Carroll.
Paper Corporation.
core
Additively manufactured AlCrFe2Ni2 with contrasting BCC/B2‐dominant and lamellar FCC + BCC/B2 microstructures exhibits the same pressure‐induced BCC/B2 → HCP transformation. Under laser heating at high pressure, HCP is destabilized, and a cubic BCC/B2 + FCC assemblage is recovered, while the lower‐scan‐speed microstructure transforms at a lower ...
Raimundas Sereika +5 more
wiley +1 more source
Annual report 2004 - Office of Tobacco Control
Office of Tobacco Control ...
Office of Tobacco Control
core
Textual: Paper, copy; 10.5” x 8” (25.4 cm x 20.3 cm)Paper from the Office of Policy Development and Research Special Studies, a portion of the Department of Housing and Urban Development, entitled "New Communities Policy Options Paper" dated June 20 ...
Office of Policy Development and Research Special Studies
core +1 more source
Impact of Hydrogen Incorporation on Electronic and Magnetic Structure of X2CrNi18‐9 Stainless Steel
Hydrogen uptake in austenitic stainless steel alters both its electronic and magnetic structure. Seebeck measurements reveal hydrogen‐induced shifts in the electronic density of states, while neutron scattering uncovers nanoscale inhomogeneities that grow upon hydrogen incorporation, with the most pronounced effect observed in the PBF as‐built state ...
Torben Tappe +9 more
wiley +1 more source
Accelerated in situ formation of TiB and TiC in Ti–5Al–2.5Sn–B4C is driven by transient liquid phase formation, which enhances particle reactions and microstructural evolution. This process increases hardness and establishes a coupled relationship between sintering temperature and reinforcement content, strongly influencing porosity in the resulting ...
Fernando. Y. Kojima, Juliano. Soyama
wiley +1 more source
Sodium nitroprusside elevation of the zinc phytoremediation potential in safflower roots [PDF]
Introduction: It was shown that the use of signaling molecules like nitric oxide donor sodium nitroprusside (SNP) can elevate phytoremediation potential of some plant species.
Shahram Namdjoyan +4 more
doaj

