Results 21 to 30 of about 3,007,416 (292)
Response of fibre optic long period gratings operating near the phase matching turning point to the deposition of nanostructured coatings. [PDF]
The response of the dual resonant bands of a fibre optic long period grating operating near the phase matching turning point to the deposition of a nanostructured coating is investigated. The dual resonant bands are observed to show a high sensitivity to
Tatam, Ralph P. +7 more
core +1 more source
A comprehensive study of the effect of a wide range of controlled human subject motion on Photoplethysmographic signals is reported. The investigation includes testing of two separate groups of 5 and 18 subjects who were asked to undertake set exercises ...
Hongwei Yuan +5 more
doaj +1 more source
Swept-source OCT with coherent imaging fibre bundles [PDF]
OCT probes for endoscopy typically use a single optical fibre to deliver light to the measurement region. 2D imaging is achieved using mechanical scanning components at the probe tip.
Tatam, Ralph P. +3 more
core +1 more source
In this paper, a hybrid sensor was fabricated using a IR-femtosecond laser to measure the thermal expansion and thermo-optical coefficient of silica-based fiber Bragg gratings (FBGs).
Litong Li +4 more
doaj +1 more source
Fibre Optic Sensors with Nano-Structured Coatings. [PDF]
A review of optical fibre devices employing nano-structured coatings is presented. Active and passive coatings, deposited using the Langmuirâ  Blodgett and electro-static self-assembly techniques, have been utilised to influence the transmission ...
Tatam, Ralph P. +3 more
core +1 more source
Low-coherence optical fibre speckle interferometry [PDF]
This paper describes the development of optical fibre low-coherence speckle interferometers capable of three-dimensional surface profiling with a resolution of 10–20 µm and a depth range of typically tens of centimetres.
Balboa, Itziar +5 more
core +1 more source
We propose a highly sensitive sensor based on a nematic liquid-crystal-filled side-hole fiber. The liquid crystal is precisely filled into an air hole of the optical fiber using a method of manually gluing in the fusion splicer.
Yijian Huang +6 more
doaj +1 more source
Multi-component strain development in superconducting magnet coils monitored using fibre Bragg grating sensors fabricated in highly linearly birefringent fibre [PDF]
The commissioning of superconducting magnet coils was monitored using embedded optical fibre Bragg grating sensors (FBG) fabricated in highly linearly birefringent (HiBi) fibre.
Adam Johnstone +15 more
core +1 more source
A Cladding-Pumped Device for Modal Gain Equilization Based on Rippled Few Mode Fiber
To achieve mode-division multiplexing (MDM) for long-distance transmission, the development of signal amplifiers, such as erbium-doped fiber amplifiers (EDFA), is crucial. As a solution for EDFA, cladding pump has gained attention due to its low cost and
Lu Dai +10 more
doaj +1 more source
Recent Progress in Fabrications and Applications of Heating-Induced Long Period Fiber Gratings
This paper presents a review of our work concerning the recent progress in fabrications and applications of heating-induced long period fiber gratings (LPFGs).
Cailing Fu +6 more
doaj +1 more source

