Results 31 to 40 of about 66,116 (307)
A Survey on the Oscillation of Difference Equations with Constant Delays
In this survey, necessary and sufficient conditions for the oscillation of all solutions of delay difference equations with one or several constant arguments, in terms of the characteristic equation, are presented.
Ioannis Stavroulakis
doaj +1 more source
The present study numerically investigated a cylinder under oscillating motions at a low Reynolds number. The effects of two oscillation frequencies and amplitudes on the lift drag coefficient, near-field surface pressure fluctuation, and far-field noise
Peixun Yu +3 more
doaj +1 more source
We are concerned with oscillation of the first order neutral delay differential equation [x(t)−px(t−τ)]′+qx(t−σ)=0 with constant coefficients, and we obtain some necessary and sufficient conditions of oscillation for all the solutions in respective cases
Songbai Guo, Youjian Shen, Binbin Shi
doaj +1 more source
New equivalent conditions for Hardy-type inequalities [PDF]
We consider a Hardy-type inequality with Oinarov's kernel in weighted Lebesgue spaces. We give new equivalent conditions for satisfying the inequality, and provide lower and upper estimates for its best constant.
Alois Kufner +3 more
doaj +1 more source
A theoretical study on the interplay of frustrated skyrmion and magnons should reveal new physics and future experiment designs. In this study, we investigate the magnon-driven dynamics of frustrated skyrmion in synthetic antiferromagnets based on ...
Z Jin +10 more
doaj +1 more source
Unique biological samples, such as site‐specific mutant proteins, are available only in limited quantities. Here, we present a polarization‐resolved transient infrared spectroscopy setup with referencing to improve signal‐to‐noise tailored towards tracing small signals. We provide an overview of characterizing the excitation conditions for polarization‐
Clark Zahn, Karsten Heyne
wiley +1 more source
Superalgebra and Harmonic Oscillator with Constant Positive Curvature
This paper has been ...
Sadeghi, J., Moayyeri, H.
openaire +3 more sources
The corrosion performance of AlSi7Mg and AlSi10Mg alloys produced through selective laser melting (SLM) was examined under compressive stress in a chloride environment. Electrochemical analyses, including open‐circuit potential (OCP), potentiodynamic polarization (CPP), and electrochemical impedance spectroscopy (EIS), were complemented by scanning ...
Femi John Akinfolarin +2 more
wiley +1 more source
Near‐Field Electrospinning Micro‐Printhead Achieves Precise Control of Nanofiber Deposition
A micro‐printhead for near‐field electrospinning enables reproducible deposition of polymer nanofibers with diameters below 50 nm. Systematic parameter studies uncover the mechanisms linking operating conditions to fiber morphology, paving the way for precise and low‐cost nanoscale 3D manufacturing.As a high‐resolution, cost‐effective, and rapid ...
Han Xu, Dario Mager, Jan G. Korvink
wiley +1 more source
Tapping mode of an atomic force microscope with a probe cantilever of a low spring constant
The work presents mathematical simulation results of tapping interaction of an atomic force microscope (AFM) probe with low (0.1 N/m) spring constant of its cantilever with samples of materials with the Young moduli of 0.01; 0.1; 1; 10 GPa under varying ...
S. O. Abetkovskaia +2 more
doaj +1 more source

