Results 61 to 70 of about 2,217,215 (210)
Abstract Continuous, high‐frequency monitoring is essential to capture rapid phenological transitions and dynamic crop responses to the environment. However, most phenotyping platforms lack the temporal resolution and automation required for consistent, season‐long trait assessment.
Worasit Sangjan +5 more
wiley +1 more source
Overvoltage Crowbar Protection Based on Passive Power Supplied Control Unit
The increase in the involvement of renewable energy sources results in a high rate of semiconductor power converter applications. The power converters provide interconnections of DC microgrids with AC distribution lines.
Strossa Jan +5 more
doaj +1 more source
Two fluorinated ethers, commonly used as heat‐transfer fluids, are explored as co‐diluents in localized high‐concentration electrolytes (LHCEs) for lithium metal‐based batteries. The best‐performing ternary diluent blend boosts ion mobility and cuts overvoltages, thereby improving Coulombic efficiency and cycle life at ≥1 mA cm−2 in zero‐excess pouch ...
Dominik Weintz +11 more
wiley +1 more source
Mechanism and suppression of breaking overvoltage of DC circuit breakers
The occurrence of breaking overvoltage in a DC circuit breaker (DCCB) poses a potential threat to the safe operation of a DC grid. Based on the structure of the ±10 kV three‐terminal DC distribution network, this paper sets up the medium‐voltage DCCB and
Lu Qu +7 more
doaj +1 more source
Automatic detection device for mining intrinsic safety power supply based on PWM
Aiming at the problems of cumbersome factory inspection steps, low inspection efficiency, and poor consistency of protection parameter measurement results for intrinsically safe power supplies used in mining, a high-precision fully automatic factory ...
Dedong ZOU
doaj +1 more source
Analysis of Overvoltages Appearing in One-Sidedly Ungrounded MV Power Cable Screen
Changing the connection type of a medium voltage (MV) cable screen is linked to a decrease in power loss, although it may also lead to the generation of overvoltage in a metallic cable screen, which is hazardous for proper cable line work. In this paper,
Aleksandra Schött-Szymczak +1 more
doaj +1 more source
This work reports a thermally safe, photothermally reprogrammable magnetic soft robot with its reprogramming temperature tuned to ∼39.5°C for biocompatibility. It achieves multimodal locomotion (max speed of 1.8 BL/s) and integrates liquid‐metal capacitive sensing to monitor self‐motion and detect environmental changes in simulated gastric environments,
Liu Yang +5 more
wiley +1 more source
A synergistic three‐layer Ni30Cu70/Ni/M catalyst, consisting of a microwave‐reduced Ni/C base, an electrodeposited Ni interlayer, and a Ni–Cu alloy top layer, was developed for alkaline HER. The Ni30Cu70/Ni/M catalyst exhibited efficient catalytic activity and stable performance over 60 h.
Aybüke Leba Akman +3 more
wiley +1 more source
Abstract Unexpectedly following launch, the Lunar Trailblazer mission experienced software anomalies that led it to orient solar panels away from the sun and lose communication with Earth. This paper describes efforts to determine the spacecraft state and attempt recovery of the mission's science at the Moon.
B. L. Ehlmann +28 more
wiley +1 more source
Original scientific paper The increasing sensitivity of electronic devices widely used in low-voltage AC systems requires an appropriate protection against voltage and current surges. Protection of the equipment against the prospective surges is based on
V. Radulovic, Z. Miljanic
semanticscholar +1 more source

