Results 1 to 10 of about 4,617,065 (299)
Oxidation Behavior of Nanocrystalline Alloys. [PDF]
Materials (Basel)Thermo-mechanically stabilized nanocrystalline (NC) alloys are increasingly valued for their enhanced mechanical strength and high-temperature stability, achieved through thermodynamic and kinetic stabilization methods. However, their fine-grained structure also increases susceptibility to internal oxidation due to higher atomic diffusivity associated ...
Karanth Y +4 more
europepmc +3 more sources
Oxidation and erosion-oxidation behavior of steels [PDF]
Materials Research, 2008 The high temperature oxidation and erosion-oxidation (E-O) behavior of steels AISI 1020, 304, 310, and 410 were determined. These steels were selected to evaluate the effect of chromium content on its E-O resistance. The oxidation behavior was determined
Stela Maria de Carvalho Fernandes +2 more
doaj +4 more sources
Dataset for DME oxidation behavior of commercial Pt/Pd-series diesel oxidation catalystsZenodo [PDF]
Data in BriefThis article presents data collected during a measurement campaign on a synthetic gas test bench (SGB) from the Chair of Thermodynamics of Mobile Energy Conversion Systems (TME). The measurement campaign consists of 23 light-off experiments.
Tom Padeken +8 more
doaj +2 more sources
Alloys, 2022 FeSiCr alloys are used as soft magnetic materials for power multilayer inductors. The alloys are typically annealed at intermediate temperatures in air during inductor fabrication to form an insulating chromium oxide layer around the alloy particles. The
Christoph Priese, Jörg Töpfer
doaj +1 more source
Oxidation behavior of SiC/SiC composites in air at high temperature
Cailiao gongcheng, 2021 As one of important candidates for advanced aerocraft engine hot components, SiC/SiC composites would undergo oxidative and corrosive damage when subjected to high temperature combustion environment. Oxidation behavior of SiC/SiC composites at 1100-1300 ℃
HONG Zhi-liang +5 more
doaj +1 more source
Materials Research Letters, 2021 The oxidation behavior of Cr2AlC MAX phase coatings with columnar and equiaxed morphologies is compared. After oxidation at 1100°C for 240 min the Cr2AlC MAX phase coatings with equiaxed grains showed a 20% lower scale thickness and a 52% larger scale ...
Xiang Chen +5 more
doaj +1 more source
Oxidation resistance performance of SiC-AlON ceramic composites at high temperature [PDF]
Processing and Application of Ceramics, 2022 The microstructure and oxidation behaviour of the pure AlON ceramics and 8 wt.% SiC-AlON composite were investigated at 700-1500°C. With increasing oxidation temperature, the surface morphology of two ceramics showed a change from acicular to flaky-like ...
Xiao Lai Rong +8 more
doaj +1 more source
Crystals, 2020 Ti6Al4V has been recognized as an attractive material, due to its combination of low density and favorable mechanical properties. However, its insufficient oxidation resistance has limited the high-temperature application.
Wenyuan Cui +3 more
doaj +1 more source
Oxidation behavior of boron-containing (Zr,Ti)CxBy solid solution ceramics at 1600 °C in air
Journal of Advanced Ceramics, 2023 Multicomponent boron-containing carbide coatings (i.e., (Zr,Ti)CxBy) on a C/C composite show good ablation resistance. However, the high-temperature oxidation behavior of this new type of boron-containing (Zr,Ti)CxBy solid solution ceramics has not been ...
Huilin Lun +3 more
doaj +1 more source
Memristive Behavior of Mixed Oxide Nanocrystal Assemblies [PDF]
ACS Applied Materials & Interfaces, 2021 Recent advances in memristive nanocrystal assemblies leverage controllable colloidal chemistry to induce a broad range of defect-mediated electrochemical reactions, switching phenomena, and modulate active parameters. The sample geometry of virtually all resistive switching studies involves thin film layers comprising monomodal diameter nanocrystals ...
Zimu Zhou +10 more
openaire +2 more sources