Results 241 to 250 of about 259,888 (302)

Partial discharge measurements

IEEE Transactions on Dielectrics and Electrical Insulation, 2008
[No abstract available]
R. Bartnikas, POMPILI, Massimo
openaire   +2 more sources

Intelligent partial discharge measurement device

Proceedings of 1994 IEEE International Symposium on Electrical Insulation, 2002
This paper introduces a entirely new intelligent partial discharge measurement device that integrates with a microcomputer, A/D, time series control and the filter amplifier circuit for analog signal. It has four independent parallel A/D channels, the highest sampling frequency is 20 MHz and data store is 512 K.
null Li Jianming, null Yang Jinping
openaire   +1 more source

Innovative Solutions for Partial Discharge Measurements

Elektrichestvo, 2021
The article discusses systems developed using an innovative approach to measuring partial discharges, their advantages over traditional methods of monitoring cable lines and electrical equipment, as well as the principles of their operation. The design of the systems is based on a special broadband sensor-antenna which provides remote recording of both
Sergey A. GOLUBTSOV, Roberto CANDELA
openaire   +1 more source

Measuring system for partial discharge

Quality Measurement: The Indispensable Bridge between Theory and Reality (No Measurements? No Science! Joint Conference - 1996: IEEE Instrumentation and Measurement Technology Conference and IMEKO Technical Committee 7. Conference Proceedings, 2002
Measuring of the partial discharge (PD) parameters of the insulating systems is very important. The prompt insulating system estimation and its remaining life time give the great savings. The new, complex PD measuring methods are now developed in the world because conventional methods do not give valid information of the insulating system conditions ...
I. Petkovic, N. Kartalovic, D. Vukic, P. Osmokrovic   +3 more
openaire   +1 more source

Partial Discharge Measurement

2014
This chapter is devoted to the measurement of partial discharges (PD) localized in weak spots of dielectrics if subjected to high test voltages. As standards for PD measurement s have been introduced only for quality assurance tests of HV apparatus energized by power frequency AC voltages (50/60 Hz), the following treatment refers mainly to this test ...
Wolfgang Hauschild, Eberhard Lemke
openaire   +1 more source

Measuring partial discharges under pulsed voltage conditions

IEEE Transactions on Dielectrics and Electrical Insulation, 2008
Partial Discharges (PDs) measurement deserves a specific study when in the presence of fast rising/falling voltages, as the output of IGBT switching devices. In such operating conditions, the choice of a proper detection system is crucial in order to have the best signal to noise ratio and to solve some problems linked to the specific characteristics ...
GUASTAVINO, FRANCESCO, DARDANO A, TORELLO, EUGENIA   +2 more
openaire   +2 more sources

Amplitude Analysis in Partial Discharge Measurement

2009 Second International Conference on Advances in Circuits, Electronics and Micro-electronics, 2009
In commercial sphere, there is obvious the pursuit of produce electrical wares with high reliability and low risk of breakdown. It is known, the Partial Discharge (PD) is regarded as a parasitic effect occurring in insulating systems. Deep investigation of Partial Discharge activity is necessary for longer service life and better reliability of high ...
Tomas Havlicek, Jiri Haze, Jaroslav Bousek   +2 more
openaire   +1 more source

Partial Discharge Measurement and Analysis

2013
Partial Discharge (PD) is a common local defect of high voltage equipment, especially insulation system of transformers. PD in the insulation of electrical equipment is a sign of dielectric defects as well as a cause of further degradation of its insulation system, which may ultimately lead to failure of the apparatus.
Sivaji Chakravorti, Debangshu Dey, Biswendu Chatterjee   +2 more
openaire   +1 more source